01-24-2010, 11:26 PM
|
#11 |
|
3" Exhaust
Join Date: Nov 2005
Location: Phoenix, AZ
Posts: 145
 |
You already have the valve covers off, so get a GOOD torque wrench and check the head bolt torque. IIRC, stock bolts should be good for ~72 ft. lb., far better than the original 58. Take a good look at a bolt head and see if it says SPS or ARP. Those are aftermarket bolts and will take a little more.
__________________
"You see, wire telegraph is like a very long cat. You pull his tail in New York and his head is meowing in Los Angeles. Do you understand this? Radio operates the same way: You send signals here, they receive them there. The only difference is there is no cat." A. Einstein 1988 and 1990 Turbo Supras |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Information about non turbo Supra | Jimbo_2JZ | Non-Generation Specific Questions | 3 | 02-20-2009 10:13 PM |
| 1988 Toyota Supra Turbo runs very rich need help | PhillyKorean | Non-Generation Specific Questions | 0 | 10-25-2008 03:28 PM |
| HorsepowerFreaks Turbo M3 vs Single Turbo Supra | ChrisB | Non-Generation Specific Questions | 0 | 01-01-2007 04:56 PM |
Threaded Mode