Forum: MKIII Supra
05-31-2008, 09:14 PM
|
|
Replies: 2
Views: 2,705
Stange Miss (2000-2500 RPM)
Car is running great, idles smoothly at 650RPM and pulls hard to redline. The timing is set correctly, but it has a strange miss at the 2000-2500 rpm range. Its a stock, manual 7mgte.
It is quite...
|
|
Forum: MKIII Supra
05-27-2008, 03:26 AM
|
|
Replies: 4
Views: 3,481
|
|
Forum: MKIII Supra
05-27-2008, 03:23 AM
|
|
Replies: 13
Views: 4,186
Disregard the post below, I didn't notice that...
Disregard the post below, I didn't notice that you had mentioned the wire with burns went to the frame. No problem with having an extra beefy wire running to ground!
Where was the "burned piece...
|
|
Forum: MKIII Supra
05-20-2008, 02:53 AM
|
|
Replies: 13
Views: 11,962
You'll want to purchase both a pilot and thrust...
You'll want to purchase both a pilot and thrust bearing... I usually use grease to drive out a thrust bearing, but supramacist's methods seems a little more cost effective, and easier to clean up.
...
|
|
Forum: MKIII Supra
05-15-2008, 01:35 AM
|
|
Replies: 9
Views: 3,230
|
|
Forum: MKIII Supra
05-15-2008, 01:29 AM
|
|
Replies: 5
Views: 2,458
Thanks for the help guys, I've tried to use...
Thanks for the help guys, I've tried to use propane to find the leak (similar to the start fluid method but with no results....)
I guess I will try the DIY boost tester, I know that the 3000 pipe...
|
|
Forum: MKIII Supra
05-15-2008, 01:24 AM
|
|
Replies: 19
Views: 4,064
|
|
Forum: MKIII Supra
05-14-2008, 04:07 AM
|
|
Replies: 19
Views: 4,064
Well if you have eliminated any possibily of...
Well if you have eliminated any possibily of water in your rear quarters or under the spare tire and determined that the sound is coming from the front engine compartment its begining to sound like a...
|
|
Forum: MKIII Supra
05-14-2008, 03:08 AM
|
|
Replies: 5
Views: 2,458
Locating Boost Leaks
Hello All,
Symptom: Car runs great (damn, not again!!!), turbo spools fast up to 250mm Hg then stays until shift. Checked all hoses and clamps, checked BOV. Found that the short 3" piece from...
|
|
Forum: MKIII Supra
05-14-2008, 12:26 AM
|
|
Replies: 9
Views: 3,230
|
|
Forum: MKIII Supra
05-13-2008, 03:03 AM
|
|
Replies: 19
Views: 4,064
|
|
Forum: MKIII Supra
05-13-2008, 01:50 AM
|
|
Replies: 19
Views: 4,064
|
|
Forum: MKIII Supra
05-12-2008, 02:20 PM
|
|
Replies: 39
Views: 15,773
I use a similar type solution. If you have lots...
I use a similar type solution. If you have lots of metric hardware around find a long bolt, two matching nuts, turn the nuts onto the end of the bolt, and lock them together. If you find its still...
|
|
Forum: MKIII Supra
05-12-2008, 12:34 AM
|
|
Replies: 11
Views: 12,863
Assuming you don't wreak your union bolt and...
Assuming you don't wreak your union bolt and union pipe, you will only have to replace the gasket washers part # 90430-22008.... If you are using silicon you might even be able to reuse them, but for...
|
|
Forum: MKIII Supra
05-11-2008, 02:58 AM
|
|
Replies: 11
Views: 12,863
Heater Union (Coolant Leak)
Symptom: Coolant leak @ rear engine, hoses and clamps are all fine, coolant running down EGR cover. (Note: Mrnickleye pointed out that coolant doesn’t pass behind the EGR cover… Tightening the EGR...
|
|
Forum: MKIII Supra
05-03-2008, 05:41 PM
|
|
Replies: 8
Views: 2,237
|
|
Forum: MKIII Supra
05-03-2008, 07:25 AM
|
|
Replies: 8
Views: 2,237
Head Gasket
Hey all,
One last question before I'm off to the races. I had both my block and head machined, but reused the old headbolts (they were in great shape) and used a stock gasket (I've had poor luck...
|
|
Forum: MKIII Supra
05-02-2008, 04:11 PM
|
|
Replies: 6
Views: 3,301
Well that certainly narrows the search down. It...
Well that certainly narrows the search down. It seemed like the top of the EGR cooler gasket was wet, but if no coolant passes within that cover, I guess I can narrow the problem down to the coolent...
|
|
Forum: MKIII Supra
05-02-2008, 06:17 AM
|
|
Replies: 6
Views: 3,301
Egr Cooler, Coolent Banjo
Hey all,
First of, thanks for all the help thus far. Got the old supra back up and running after replacing the problem rod bearing. Runs like a top, no CEL!.
As for my problem, I seem to be...
|
|
Forum: MKIII Supra
04-26-2008, 05:49 PM
|
|
Replies: 9
Views: 7,295
|
|
Forum: MKIII Supra
04-26-2008, 05:45 PM
|
|
Replies: 5
Views: 2,548
|
|
Forum: MKIII Supra
04-25-2008, 02:26 AM
|
|
Replies: 5
Views: 2,548
|
|
Forum: MKIII Supra
04-24-2008, 02:19 AM
|
|
Replies: 5
Views: 2,548
strange bracket.... 7mgte
Hey all, anyone have any idea which bracket this is?
(Funny thing is I didn't take this picture, someone else did and the caption was what the hell is this.....)
|
|
Forum: MKIII Supra
04-21-2008, 08:51 PM
|
|
Replies: 9
Views: 7,295
thanks
Cre,
thanks for the info.... It would probably be a mistake to bolt it to the hot terminal of the start then eh?
Any chance you can tell me where the main engine body ground strap should run...
|
|
Forum: MKIII Supra
04-21-2008, 04:25 PM
|
|
Replies: 9
Views: 7,295
ring connector...
Thanks, i have no problem with the two longer connectors that pass by the transmission,
I am looking for where the ring lug goes, (theres a picture of the ring above).
Thanks,
|
