|
![]() |
#8 |
3" Exhaust
Join Date: Jun 2011
Location: Wisconsin
Posts: 177
![]() |
![]()
Damn. Cre do u remember how u managed to remove that put that was held in place by that "e" clip? The clip was easy as hell to remove once i had my head at the right angle and wasnt straining my neck so damn bad. lol. But i sprayed penetrating oil on the pin and it still wont budge. Im debating weather i should slide the engine back in a little bit to maybe relieve some pressure on the fork? idk. Im so frustrated. I would take the trans out too but im working in my dads garage and i am limited on room. if it were summer i would just work in the driveway.
__________________
1988 7M-GTE Manual Turbo, Godspeed IC, Stock HG Torque to 90FP W/ Arp bolts, Silicon water hose kit, silicon vacuum hoses, Godspeed radiator, 2 12" electric fans. |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
HELP!: 7MGTE engine block info needed | barton | MKIII Supra | 1 | 05-19-2010 05:54 PM |
HELP!: 7MGTE engine block info needed | barton | MKIII Supra | 6 | 04-14-2010 09:28 PM |
Well crap! Advice needed with shot engine | finaltable | MKIII Supra | 10 | 03-13-2008 07:35 PM |
change oil pump without pulling engine | Jjona5 | MKIII Supra | 2 | 02-11-2007 03:29 AM |
Pulling Engine and trans | adamh88 | MKIII Supra | 3 | 01-15-2007 05:36 PM |