|
![]() |
#2 |
12psi boost
Join Date: May 2006
Location: Athens, TX
Posts: 308
![]() |
![]()
Ok I fugured out the initial problem but now have a new one. I didnt think I needed the turbo pressure sensors but now I have them on there and the motor acts a lot better. But now it has a low RPM miss like it is running rich and also black smoke coming from the tail pipe only when you rev it. Not sure if my TPS is off or what and not sure the procedure for adjusting it. If not that I am not sure all of the injectors are working good and the only thing that is different than the original setup in the clip is that I havent got my new inter cooler and just have the boost straight piped from one side to the other. I have been around a lot of turbo cars but never owned one so this is all new to me a little.
__________________
1987 supra NA 5 speed 1JZGTE swap Tokico Illumina 2 and Eibach springs Tokico pillow blocks Suspension Techniques front and rear sway bar HKS super dragger cat-back exhaust plus test pipe Greddy Profec B spec 2 boost controller HKS type 1 turbo timer Supra sport solid steel drive shaft Walboro 255 fuel pump JZA70 Front end mod 18" Volk Racing AV3 18x8.5 front 18x9.5 rear |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Starter Removal question | OkieRA29 | MKIII Supra | 13 | 05-11-2010 12:08 AM |
prepping block for headgasket question | dannydavi | MKIII Supra | 1 | 12-06-2008 07:44 AM |
Buying supra need advice guys | sisqojazz | Non-Generation Specific Questions | 1 | 03-21-2007 10:47 PM |
Hello guys, new here with a question | Andy M | MKIII Supra | 11 | 10-16-2005 07:43 AM |
Sup Guys..!!!! | Ruben | Non-Generation Specific Questions | 29 | 07-06-2005 09:38 PM |