start up fail help!!!!

El_supracabra · 03-17-2011, 02:11 AM

Yes it is a 7mge. OF COURSE I used assembly lube. Lol

I was wondering if maybe the flywheel was too thick or something (perhaps causing the pressure plate not to release the clutch? Idk)

I'm not home right this minute, but I will def try to turn the motor "backwards" by hand a little to "dislodge" or realign whatever is "jamming". I think my clutch cylinder may need to be bled. Weird considering I didnt disconnect any hydraulic clutch lines. I did notice my resevoir was almost empty.... But that still wouldn't cause the thing to lock up that tight. I'm wondering if maybe I should loosen the bellhousing bolts a little to see if that helps loosen things up? Or maybe put it in gear and try to turn the driveshaft?

Anyways thanks a lot guys. Keep the suggestions coming, and I will def let you know what I find!

03-17-2011, 02:11 AM	#11
El_supracabra Intake Join Date: Feb 2011 Location: South of Columbus, Ohio Posts: 45	Yes it is a 7mge. OF COURSE I used assembly lube. Lol I was wondering if maybe the flywheel was too thick or something (perhaps causing the pressure plate not to release the clutch? Idk) I'm not home right this minute, but I will def try to turn the motor "backwards" by hand a little to "dislodge" or realign whatever is "jamming". I think my clutch cylinder may need to be bled. Weird considering I didnt disconnect any hydraulic clutch lines. I did notice my resevoir was almost empty.... But that still wouldn't cause the thing to lock up that tight. I'm wondering if maybe I should loosen the bellhousing bolts a little to see if that helps loosen things up? Or maybe put it in gear and try to turn the driveshaft? Anyways thanks a lot guys. Keep the suggestions coming, and I will def let you know what I find! __________________ 86.5 Supra NA: milled head .020, decked block .007, .5mm+ pistons, port & polished intake manifold and cyl head,OBX header, 3-angle, cold air intake, Cometic MLS HG. ALL NATURAL! CHEVROLET- Cracked Heads, Every Valve Rattles, Oil Leaks Every Time FORD- Flipped Over, Rebuilt Dodge DODGE- Dirty Old Dust Gathering Engine I'd rather drive a Toyota, than push a ford.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
car suddenly wont start - never ran great anyway, esp. cold, now cranks, but won't st	rjSupra	MKIII Supra	41	03-21-2014 05:27 PM
87 Supra won't start	RNEMESiS42	MKIII Supra	3	06-25-2011 06:30 PM
Stalling at start up	Green7mgte	MKIII Supra	4	12-15-2009 06:31 PM
My car decides when it wants to start	carfanatic89	MKIII Supra	16	02-12-2008 07:50 PM
Car Died...where to start?	Jrew	MKIII Supra	4	10-26-2007 02:19 PM