09-18-2005, 03:48 PM
|
#3 |
|
Lexus & 550's
Join Date: Aug 2005
Location: In the shadows
Posts: 506
 |
actuator
ya it works ok on the bench, however i just dont trust this modded actuator so i ordered a new dual port actuator. i could not get the new side of the actuator to seal good enough around the actuator rod. And no, i wish i would have replaced the bhg 2 yrs ago with a new metal gasket but i went with a toyo dealer gasket. I was just trying to get the car running then and i was poor at the time. so i dont go over 14 psi for now. blew the waistgate vacume line last week and i went over 20psi on accident once. but so far so good, still holding in there.
thanks |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Manual Boost Controller and Turbo timmer question | ethan12510 | MKIII Supra | 5 | 02-20-2008 10:54 PM |
| manual boost controller!!!!!!! | justin1642 | MKIII Supra | 6 | 01-16-2007 10:01 PM |
| boost control | southernsupra | Non-Generation Specific Questions | 0 | 04-25-2006 04:11 AM |
| Manual boost control (bleed valve?) | sexy91tt | MKIII Supra | 1 | 01-28-2006 05:42 PM |
| installing manual boost controller 1989?? | hamburgler | MKIII Supra | 4 | 07-13-2005 12:55 PM |
Threaded Mode