01-02-2010, 09:26 PM
|
#27 |
|
3" Exhaust
Join Date: Aug 2009
Location: Southern Oregon Coast
Posts: 83
 |
Timming
When putting the distrib back in - be sure the center of the rotor blade is lined up on the #1 spark wire terminal when crank is TDC on fire stroke (remember its TDC twice, once on fire and once on exhaust so be sure you got the right one.)
You can put the distrub cap to locate the #1 terminal and then mark the mark the housing with a perm marker so you can remove the cap to see the rotor . Be sure to rotate crank severl rev by hand to be sur the rotor always goes back to #1 terminal when at TDC on crank. This will get close enough to start. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lower Ball Joints - Checking here first | Grandavi | MKIII Supra | 3 | 09-20-2008 04:04 AM |
| Picking up my 89 tomorrow | 8uwav6 | Show n Tell | 2 | 03-31-2008 08:08 PM |
| Checking Thermostat | scruffboy | Non-Generation Specific Questions | 6 | 03-09-2006 05:49 PM |
| Supra Noob checking in from Florida | PalmCoastMk3 | Non-Generation Specific Questions | 1 | 12-23-2005 05:08 PM |
| Supra Newb Just checking in | Razor | Non-Generation Specific Questions | 1 | 12-21-2005 04:15 AM |
Threaded Mode