Putting JDM engine in!!! :D

89suprat · 10-23-2009, 11:06 PM

also just to note its near the bottom left corner. and ive have the vacuum line unhooked atm. but not to deviate from that too much my turbo shaft snapped leaving the turbine i think(whatever the exhaust side is) freely bobbing around making a wicked noise. basically the internals exploded sending most of my oil and coolant into the exhaust. so far i have rerouted the coolant lines into each other and connected my maf sensor inline to the throttle body directly. it is all running very well except for a minor leak from putting a custom made elbow to route the oil back to the pan. i can beef it up with bigger parts but what i wanted to know is would it be bad if i blocked the turbo oil lines off with a plate. i havent done it cause i figured it would mess up oil delivery and pressure.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Engine Help!	born2drv	MKIII Supra	9	02-01-2011 08:14 PM
rebuilt hard to crank (high engine resistance); need advice	cbrewster	MKIII Supra	4	09-28-2009 04:52 PM
problem seperating engine from manual tranny	Gengus	MKIII Supra	7	01-29-2008 12:10 AM
Need help putting engine back together	GreenChevelleSS	MKIII Supra	18	12-17-2005 05:37 PM

10-23-2009, 11:06 PM	#13
89suprat Stock Join Date: Oct 2009 Location: ottawa Posts: 5	also just to note its near the bottom left corner. and ive have the vacuum line unhooked atm. but not to deviate from that too much my turbo shaft snapped leaving the turbine i think(whatever the exhaust side is) freely bobbing around making a wicked noise. basically the internals exploded sending most of my oil and coolant into the exhaust. so far i have rerouted the coolant lines into each other and connected my maf sensor inline to the throttle body directly. it is all running very well except for a minor leak from putting a custom made elbow to route the oil back to the pan. i can beef it up with bigger parts but what i wanted to know is would it be bad if i blocked the turbo oil lines off with a plate. i havent done it cause i figured it would mess up oil delivery and pressure.