shooting coolant out of reservoir/defunct heater

[tsupranami]

Engine pulled. Check.

Was it a complete rebuild? Did you or the shop pull the crank & pistons? Are the new pistons stock? Oversized? Same compression ratio?

Was the block deck resurfaced? If so, how much was taken off? Was the head milled also? How much was taken off of it?

Does FelPro make HG's in different thicknesses?

No heat. Check.

No heat = no hot water in heater core *and/or* airflow blocked by debris in ventilation system.

No hot water in heater core = no water flow(control valve(s) not operating) *and/or* no water (air in system.)

No water flow = control valve(s) not operating(firewall hvac and/or thermostat) *and/or* heater control unit not operating (dash unit and/or vacuum actuator)

No water in heater core = incomplete fill and bleed *and/or* leak in cooling system

Incomplete fill and bleed - Did someone forget to have the heater on (heater core valve open) when the system was filled and bled?

The heater hose into the control valve at the back of the engine is higher than the cap. Trapped air here causes lots of problems on the 7M's. Sounds like you're aware of that, though.

Leak in cooling system = internal *and/or* external

No external leaks and all other systems are good (thermostat, radiator, cap, water pump, no collapsed hoses, etc.) = engine is overheating (abnormal timing / fueling) *and/or* there is an internal leak.

Internal leak = water in oil/oil in water *and/or* water in cylinder(s)

Water in oil/oil in water = Milkshake of Death

Water in cylinders = air in cooling system *and/or* cracked head (<1%), cracked block (<0.5%), BHG (98.5%).

Clear as Mud? Check. lol!

Hope that helps. Good luck! Keep us posted.