|
|
05-05-2008, 09:25 AM
|
#1 |
|
500whp yet?
Join Date: Nov 2005
Location: Mechanicsville, MD, US of A, 20659
Posts: 1,060
 |
the clip typically has a rubber boot that goes over top of the connection. i also believe the wire is slightly longer then the rest
__________________
88 N/A w/ 5spd - stock - not running, bhg 87 turbo/targa w/ 5spd- fidanza light weight flywheel, new oem slave cylinder, apexi air filter, no ac and no heat |
|
|
|
05-05-2008, 12:11 PM
|
#2 |
|
3" Exhaust
Join Date: Mar 2008
Location: Columbia, SC
Posts: 69
|
Thats what im talking about. Problem is I do not have it. Picture would be nice
 Used JDM engine was dropped into car. USDM wiring harness was kept so some adjustments had to be made to work with JDM motor. The connection was cut so its just a wire hanging there, no connector nothing. Instead, the after market gauge was hooked up. The connector on it now looks like this: 
__________________
Zach |
|
|
|
|
05-06-2008, 01:41 PM
|
#3 |
|
500whp yet?
Join Date: Nov 2005
Location: Mechanicsville, MD, US of A, 20659
Posts: 1,060
|
you can try using the spade connector on the oem sender, dont see why it would be a problem. goto the website of the manufacturer of your aftermarket gauge and look for the installation instructions and make sure its installed correctly
__________________
88 N/A w/ 5spd - stock - not running, bhg 87 turbo/targa w/ 5spd- fidanza light weight flywheel, new oem slave cylinder, apexi air filter, no ac and no heat |
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 7MGE oil pressure | Arne (Denmark) | MKIII Supra | 14 | 07-31-2009 10:07 PM |
| Removing the oil pressure sender??? | supersupramk3 | MKIII Supra | 1 | 02-23-2009 08:42 PM |
| Fuel pump relay and pressure. | carfanatic89 | MKIII Supra | 8 | 05-01-2008 06:39 PM |
| Petrol Gauge Sender Supra Mk3 | supra mk3 brunei | MKIII Supra | 0 | 02-17-2008 04:14 PM |
| oil pressure | johnkarl | MKIII Supra | 2 | 11-05-2006 02:11 PM |
Hybrid Mode
