04-30-2008, 02:19 PM
|
#16 |
|
3" Exhaust
Join Date: Oct 2007
Location: Norwalk, Ca
Posts: 52
 |
Finally put it back together. put a new head gasket and water pump just because. but its putting out even more smoke than before. when i got the head back from the machinist it had ridges the whole way across the surface. was it supposed to be like that? also its shooting out smoke from the pcv and theres a lot of pressure in the valve covers.am i going to have to take it apart again and have the head reresurfaced? did i not torque it right, i put it to 75 ft/lbs.
this sucks ass Last edited by paulmicin; 04-30-2008 at 02:28 PM. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Compression check when cold | gottadiesel | MKIII Supra | 3 | 02-26-2009 07:24 AM |
| Compression and Block Tests | mrnickleye | Supra FAQ | 0 | 01-29-2007 03:49 AM |
| Just did compression test...Help with oil pressure! | 2JZEFINI-17 | MKIII Supra | 1 | 11-06-2006 12:06 AM |
| looking at a 90 turbo with compression problems | jtitzer56 | MKIII Supra | 1 | 09-23-2006 05:27 PM |
| Compression Question | Intenseneal | MKIII Supra | 5 | 08-15-2005 10:27 AM |
Threaded Mode