02-05-2006, 03:30 AM
|
#11 |
|
3" Exhaust
Join Date: Dec 2005
Posts: 74
 |
There are a lot of posts on this as this is a common problem. You MUST have the head milled and make sure the block surface is extra clean from past gasket material. Check for warpage and cracks on the block surface as well as the head. Overlooking this could cause another BHG. You will be replacing more than just the head gasket, i.e. the EGR gaskets. Buy a gasket kit. Keep track of the bolts, and take notice what connectors go where. Have patience. Good luck
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Blown Head Gasket Snake Oil | unkymurch | Non-Generation Specific Questions | 21 | 08-06-2010 02:11 AM |
| 1989 Supra blown head gasket | rayk5799 | Non-Generation Specific Questions | 6 | 05-18-2009 10:51 AM |
| Update: Blown Head Gasket Snake Oil - 8 months later | unkymurch | Non-Generation Specific Questions | 3 | 12-17-2008 09:35 PM |
| Blown head gasket? | h8z2luze | MKIII Supra | 30 | 06-03-2006 03:18 AM |
Threaded Mode