question on removing crank shaft - Page 2

kidsusukigsxr · 07-07-2007, 03:18 AM

Hello i used the starter method and it came RIGHT OFF. I've been working on my car since. i have new problem i made sure i was careful putting things back. after my timing belt replacment one of the belts is shacking it doesn't look like the crank shaft nor the other pulleys are wobbling. (funny) one of the belts is shacking. can anyone tell me if they know whats wrong.

IHateHacks · 07-07-2007, 10:59 AM

What did you torque the crank bolt to?

kidsusukigsxr · 07-07-2007, 03:49 PM

195 as recommended. when putting it on the pulley i changed the casket and i didn't use the recommended tool to put the pulley back on. Should i retrace my steps and do it all over again? or will i have to replace the pulley and whatever else bends.

07-07-2007, 03:18 AM	#11
kidsusukigsxr 3" Exhaust Join Date: Dec 2006 Location: Orlando, Fl Posts: 52	Yup Hello i used the starter method and it came RIGHT OFF. I've been working on my car since. i have new problem i made sure i was careful putting things back. after my timing belt replacment one of the belts is shacking it doesn't look like the crank shaft nor the other pulleys are wobbling. (funny) one of the belts is shacking. can anyone tell me if they know whats wrong.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Crank Shaft Pully Question	kidsusukigsxr	Non-Generation Specific Questions	1	04-15-2011 08:45 PM
Prop/Drive Shaft, brake question	spudz29212MKIII	MKIII Supra	13	05-31-2008 07:15 PM
Need help with front crank shaft pully bolt	tmetal_blk	Non-Generation Specific Questions	3	06-24-2007 06:24 PM
crank shaft pulley puller	supramacist	MKIII Supra	30	04-18-2007 02:27 AM
Crank shaft pulley..	MA70_858	Non-Generation Specific Questions	3	07-28-2006 04:47 PM

07-07-2007, 10:59 AM	#12
IHateHacks 20psi boost Join Date: May 2006 Location: New Haven/Hamden Posts: 793	What did you torque the crank bolt to?

07-07-2007, 03:49 PM	#13
kidsusukigsxr 3" Exhaust Join Date: Dec 2006 Location: Orlando, Fl Posts: 52	195 as recommended. when putting it on the pulley i changed the casket and i didn't use the recommended tool to put the pulley back on. Should i retrace my steps and do it all over again? or will i have to replace the pulley and whatever else bends.