Little Help Please

[jeepkaiser65]

hey supra you should let me have thatengine in the pic so i can umm... match it up with mine ill give it back when im through

[suprra_girl]

no problem scruff

and jeep....... no

if you look in show n tell you'll find my build thread somewhere and you can see what she looks like at the mo (still under build tho)

[scruffboy]

Ain't ya worried about all the heat that's going to be thrown off by that thing? How do ya compensate for that. I was thinking of installing a header and a more opened intake, but I'm afraid of heat fryin the sh*t out of everything. I have an N/A so I would like somethin to up the horsies a little.

P.S. You were extremely helpful to me and I appreciate it.

Scruffboy

[suprra_girl]

nahh not really... i figure.. if it does start heating other stuff up a bit too much then i'll do something about it lol, you could maybe put a couple of washers in your bonnet hinges to raise it a little to let some of the heat out if it is a problem

but i don't suspect it will be any more than what the stock manifold puts out

& no problem, glad i could help

[Murd]

Could always get the manifold ceramic coated and thermal taped if it's an issue.

[j3pz]

im gonna tape mine cause my old motor burnt some of the stuff up, and i dont want that to happen to this one...

how much did that header and turbo cost ya? im debating upgrading to a t4 or rebuilding the ct26

[suprra_girl]

unless you have $2k spare don't bother changing the gte manifold & turbo as there is alot of other little work required to get it all running

exhaust
reweld in stock 02 sensor into new downpipe
oil feed and drain hoses and fittings for all the hoses
new intake with plumback holes for isc, bov and pcv hoses
new air filter (don't wanna damage that new turbo)
block off water lines if your new turbo isn't watercooled (loop don't block)
buy an external wastegate if the new turbo isn't internally gated
if going external then welding in the dump tube to the exhaust so you don't fail your warrant check
if your turbo is internal then getting a block off flange made for the external flange on the exhaust manifold (ideally getting it cut off and welded shut as close to the runners as possible

i think that's pretty much it but you are in for a fair bit of work when going aftermarket turbo

so... get that ct rebuilt and upgraded lol