That may be a Lexus part number - please check if your dealer can find it under Lexus.

Yes, the metal 'tooth' plate on the crankshaft can come loose, and/or the magnetic pick-up sensor (or its harness) can be faulty. The troubleshooting steps in the TSRM go through diagnosing and correcting any of these possible issues.

Need help making power 94tt
 

So i swop my ecu,igniter and coils with other ones today and tried a new set of plugs[again] still the same miss.
It leaves me with crank pick up and injectors to test.
I see if i plug out my map sensor it revs a bit beter.

Note: The toothed gear behind the crank pulley/dampener can get knocked off - it's only a press-fit.

Please keep us informed.

Need help making power 94tt
 

Took car back to the dyno my tuner say it is running lean he think there is something wrong with the fuel pump but will keep updated as soon as i know something.

Need help making power 94tt
 

Took the injectors in today to get tested only one was right.
Think it is maybe fake bosch inj.
will buy new ones soon

Need help making power 94tt
 

Bought new injectors car is 100% now.Did a breakfast run today drove her 300 km far no problems.

That's an unusual problem. Did the original injectors you purchased come with any sort of warranty?

Although hindsight is 20-20, would you agree that whenever possible, other forum members reading this should stick with proven-reliable sources for parts (ideally name-brand parts)? I know this is tough when you're on a budget, but (again in hindsight, and for example) bad injectors really could have ruined the engine... Also, please let me know if there's anything I'm missing in this analysis/recommendation/lessons-learned post.

Need help making power 94tt
 

No they had no warranty but yes wen it comes to parts stick to brand names and make sure they are not fakes,specially wen it comes to fuel and timing.

Need help making power 94tt
 

I have 1 or 2 problems on the car that must be fiks it drives fine at 0.9bar but at 1.5bar it feels like the wasgate is opening and closing going to look at that next.
I also had her at the 1/4mile boosting 0.9 why to much wheelspin had 225 semis on the back just to test her.

Please remind me - what kind of boost controller are you using? Also, what is the boost specification of the spring that's in your wastegate?

What's a "semis"? Is that the same as a "Drag Radial"? Also, why only 225 width (that seems pretty darn narrow).

315-width drag radials on 11.5" width rims are very popular here in the US for the strip. Also (of course MT drag slicks).
http://www.bfgoodrichtires.com/tire-...techspec_table
http://www.mickeythompsontires.com/s...hp?item=ETDrag