hks head gasket

supramacist · 05-29-2007, 07:57 PM

Alright, You have the HKS beaded MHG. It's a good gasket. Should work well for you. There's this thing in this forum where everyone debates the mhg's.

I think because most people don't deck the block and only plain the head, is the basis of the argument, because in theory with out doing the block and the head, the surface isn't flat enough for an MHG.

I lapped my block, I did it in the car even. Some would say that is wrong.
But to the point. I had the head done completely. I used an HKS 2.mm stopper mhg. So atleast I'll never be accused of cutting corners or skimping on parts.

I almost went beaded and wanted to spend more money than I needed too.

I'm not done with my build just yet thanks to some of my vendors not working over the holiday. I'm down to a few pipes and som vac lines. Oil change then fire.

EDIT: I used arp studs. Be e a utifull.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Blown Head Gasket Snake Oil	unkymurch	Non-Generation Specific Questions	21	08-06-2010 02:11 AM
1989 Supra blown head gasket	rayk5799	Non-Generation Specific Questions	6	05-18-2009 10:51 AM
Head Gasket replacement questions.	DavidLeClair584	MKIII Supra	1	06-09-2007 09:17 PM
Buying a 87, head gasket questions	Gengus	MKIII Supra	1	04-14-2007 07:15 PM
Head Gasket Part II	Bullz_EyE	MKIII Supra	2	01-26-2006 06:30 PM

05-29-2007, 07:57 PM	#6
supramacist 1000whp postwhore Join Date: Apr 2007 Location: Escape from the Prison Planet Posts: 1,356	Alright, You have the HKS beaded MHG. It's a good gasket. Should work well for you. There's this thing in this forum where everyone debates the mhg's. I think because most people don't deck the block and only plain the head, is the basis of the argument, because in theory with out doing the block and the head, the surface isn't flat enough for an MHG. I lapped my block, I did it in the car even. Some would say that is wrong. But to the point. I had the head done completely. I used an HKS 2.mm stopper mhg. So atleast I'll never be accused of cutting corners or skimping on parts. I almost went beaded and wanted to spend more money than I needed too. I'm not done with my build just yet thanks to some of my vendors not working over the holiday. I'm down to a few pipes and som vac lines. Oil change then fire. EDIT: I used arp studs. Be e a utifull.