|
|
04-20-2007, 04:55 PM
|
#1 |
|
12psi boost
Join Date: May 2006
Location: Athens, TX
Posts: 308
 |
About the struts I have the illumina 2's on mine you dont need TEMS to use them just adjust them manuely. But anyways they are great little stiff but I like my ride like that. They also look good with the eibachs. As for the clunking noise mine did that and it was the tie rod ends the right side was borke I replaced it went away. Easy way to check it remove it from the spindle and move it around if it is broke you will feel cracking inside of it they are pretty cheap. They were prolly broke and when he did the alignment it got worse.
__________________
1987 supra NA 5 speed 1JZGTE swap Tokico Illumina 2 and Eibach springs Tokico pillow blocks Suspension Techniques front and rear sway bar HKS super dragger cat-back exhaust plus test pipe Greddy Profec B spec 2 boost controller HKS type 1 turbo timer Supra sport solid steel drive shaft Walboro 255 fuel pump JZA70 Front end mod 18" Volk Racing AV3 18x8.5 front 18x9.5 rear |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ABS Problem? | rasclaat_98 | MKIII Supra | 6 | 12-13-2010 09:53 PM |
| speed sensor problem | nadircicek | Non-Generation Specific Questions | 8 | 10-09-2009 05:58 PM |
| another heater problem | nicnet | MKIII Supra | 16 | 12-05-2007 10:18 PM |
| Need hlep with suspension problem. | abhattan | MKIII Supra | 7 | 03-06-2007 03:43 AM |
| Boost Problem, I Guess | nonstop213 | MKIII Supra | 0 | 02-23-2006 07:32 PM |
Hybrid Mode
