crank shaft pulley puller

IHateHacks · 04-18-2007, 02:07 AM

LMAO @ the mr.potato head style comment.

Sorry, I'm not doubting your mechanical ability.......wait, I guess I am

No, but seriously, are you SURE you are trying to loosen it and not tighten it? Seriously. Hey I have to cover all the bases here.

You should not be moving the entire motor.

Here's the deal, its not about strength when getting a bolt off its about LEVERAGE. You said you used a 1 foot pipe to extend the breaker bar? That is your problem, all of your effort is going into moving the motor on its mounts. Go get a 3ft, better yet a 4ft small diameter steel pipe just big enough to slide over the handle of the breaker bar. If you get one long enough, your little sister will be able to break it loose. Its about leverage not strength.

supramacist · 04-18-2007, 02:27 AM

I gotcha man.

I'm going to get the screw driver aforely stated and give it a go.
I'm not giving up yet.

It's like ROCKY VII in this mug, ya here.

lol

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
1980 Supra Crank Pulley (Harmonic Balancer)	steve6163	Non-Generation Specific Questions	7	06-18-2010 01:47 AM
Crank Pulley Removal	go.stfu	MKIII Supra	4	07-12-2007 11:16 PM
question on removing crank shaft	kidsusukigsxr	Non-Generation Specific Questions	12	07-07-2007 03:49 PM
Unorthodox Supra Ultra S - Lightened Crank Pulleys	Kuban	MKIII Supra	1	03-13-2007 09:39 PM
Crank shaft pulley..	MA70_858	Non-Generation Specific Questions	3	07-28-2006 04:47 PM

04-18-2007, 02:07 AM	#1
IHateHacks 20psi boost Join Date: May 2006 Location: New Haven/Hamden Posts: 793	LMAO @ the mr.potato head style comment. Sorry, I'm not doubting your mechanical ability.......wait, I guess I am No, but seriously, are you SURE you are trying to loosen it and not tighten it? Seriously. Hey I have to cover all the bases here. You should not be moving the entire motor. Here's the deal, its not about strength when getting a bolt off its about LEVERAGE. You said you used a 1 foot pipe to extend the breaker bar? That is your problem, all of your effort is going into moving the motor on its mounts. Go get a 3ft, better yet a 4ft small diameter steel pipe just big enough to slide over the handle of the breaker bar. If you get one long enough, your little sister will be able to break it loose. Its about leverage not strength.

04-18-2007, 02:27 AM	#2
supramacist 1000whp postwhore Join Date: Apr 2007 Location: Escape from the Prison Planet Posts: 1,356	I gotcha man. I'm going to get the screw driver aforely stated and give it a go. I'm not giving up yet. It's like ROCKY VII in this mug, ya here. lol