ding protecter removal need help

supraman121 · 01-09-2007, 06:53 PM

How do i remove the ding protecter ruber peices? not the whole trim just the ruber peice on the out side. ive circled them in red.

dcrusupra · 01-09-2007, 07:41 PM

The front ones where the turn signals are, are held in by the screw in the turn signal and the screw inside the wheel well. The ones on the front fenders in front of the door are held in by a screw in the wheel well and a clip, the ones on the door are held in by clips, and the ones on the back are held on by screws. To get to the screws you'll pretty much have to disassemble the entire rear interior.

Edit - I think the ones on the door may be held in by a screw or 2. Take the door panel off to make sure. Thats not that hard to do either. Just a couple of screws on the front of the panel and a couple under the carpeted pocket on the bottom of the door. Then the top is just hooked onto the top of the door. So just lift the bottom and pull up on it, dont forget to disconnect the light in the corner along with the window switches.

01-09-2007, 06:53 PM	#1
supraman121 12psi boost Join Date: Aug 2006 Location: North Carolina Posts: 361	ding protecter removal need help How do i remove the ding protecter ruber peices? not the whole trim just the ruber peice on the out side. ive circled them in red. __________________ Upgrades- 225/50/R16's Kumho ECSTA AST (KU25) 273 bucks with shipping Magnaflow exhaust NO KAT K&N Air Filter www.myspace.com/coreyjstevens http://vids.myspace.com/index.cfm?fu...oid=1536317037 <------ this one should work check out the accident one aswell ya i might be a "fat kid" but i sure can move fast!~

01-09-2007, 07:41 PM	#2
dcrusupra 500whp yet? Join Date: Aug 2005 Location: Plantation, Fl. Posts: 1,052	The front ones where the turn signals are, are held in by the screw in the turn signal and the screw inside the wheel well. The ones on the front fenders in front of the door are held in by a screw in the wheel well and a clip, the ones on the door are held in by clips, and the ones on the back are held on by screws. To get to the screws you'll pretty much have to disassemble the entire rear interior. Edit - I think the ones on the door may be held in by a screw or 2. Take the door panel off to make sure. Thats not that hard to do either. Just a couple of screws on the front of the panel and a couple under the carpeted pocket on the bottom of the door. Then the top is just hooked onto the top of the door. So just lift the bottom and pull up on it, dont forget to disconnect the light in the corner along with the window switches. __________________ New Rebuild My CarDomain

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
engine removal	mizuboi	MKIII Supra	11	06-10-2011 06:25 AM
Starter Removal question	OkieRA29	MKIII Supra	13	05-11-2010 12:08 AM
86.5 auto transmission removal HELP!!!	elmer	MKIII Supra	13	04-06-2010 10:41 PM
Alternator belt removal and installation!	~B Magical~	MKIII Supra	11	03-13-2008 07:27 PM
Is this true? Fuse removal can change limiter	jdbones	Non-Generation Specific Questions	0	12-30-2007 10:31 AM