07-03-2006, 01:42 PM
|
#6 |
|
walbro fp
Join Date: Sep 2005
Location: Kearny, New Jersey, USA
Posts: 427
 |
Re: Broken Bolt
I bought a small Dremel rechargable hand gaget that should allow me to start a hole with a drill bit. I bought a set of extractors that should let me get it into the hole and then work on backing it out. I've never done this before, and I would hate to screw this up. The one bolt is holding nicely and there are no leaks, but I hate the though of just one bolt holding it in place. Should I go ahead and attempt to back out the broken bolt, or am I just going to make more of a mess then it already is?
Thanks, Scruffboy |
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A Little Story about a crank bolt | abhattan | MKIII Supra | 17 | 03-28-2013 01:06 AM |
| Targa Top bolt is striped out | gtmustangman | MKIII Supra | 7 | 02-08-2009 02:41 PM |
| stripped rear end bolt | 87 Supra | MKIII Supra | 5 | 10-16-2007 02:40 PM |
| Bolt Snapped - Sealant? | go.stfu | Non-Generation Specific Questions | 3 | 07-25-2007 03:28 PM |
| Broken Bolt | scruffboy | Non-Generation Specific Questions | 6 | 10-31-2006 01:33 PM |
Threaded Mode