Having trouble getting motor separated from tranny...

shawn87gta · 12-14-2005, 09:49 PM

Well, I've tried prying but they're still stuck. I have some steel wedges and tapped them in between the motor & tranny to hold the gap I've gained so far, but I'm leary of continuing to drive them in too hard. I'm debating on it - has anyone done this or have any opinions on whether it would work or not? Is there much risk of damaging the bell housing by doing this? I'm not worried about the motor, I just don't want to tear up the tranny. I also wonder if anyone can tell me how far apart the motor & tranny need to come to completely disengage the input shaft to know if I'm close yet or is there still a ways to go?

Thanks!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Tranny ? Need Info!	SilverBullet05	Non-Generation Specific Questions	0	07-07-2008 09:45 PM
Auto Tranny Issues?	jbjorndal	MKIII Supra	3	03-14-2008 09:31 AM
problem seperating engine from manual tranny	Gengus	MKIII Supra	7	01-29-2008 12:10 AM
clutch slip	skunk	MKIII Supra	11	11-29-2005 08:33 PM

12-14-2005, 09:49 PM	#10
shawn87gta Stock Join Date: Nov 2005 Posts: 22	Well, I've tried prying but they're still stuck. I have some steel wedges and tapped them in between the motor & tranny to hold the gap I've gained so far, but I'm leary of continuing to drive them in too hard. I'm debating on it - has anyone done this or have any opinions on whether it would work or not? Is there much risk of damaging the bell housing by doing this? I'm not worried about the motor, I just don't want to tear up the tranny. I also wonder if anyone can tell me how far apart the motor & tranny need to come to completely disengage the input shaft to know if I'm close yet or is there still a ways to go? Thanks!