11-11-2011, 01:42 PM
|
#2 |
|
3" Exhaust
Join Date: Apr 2011
Location: columbus
Posts: 151
 |
yes, get the head machined...and have them chemical bathe it. But, if u go metal, u will probably need the block machined also. Metal hg requires a very smooth surface. like...brand new type smooth. I ended up going with a ishino composite headgasket and arp studs instead of bolts. studs are alot stronger then bolts, and i didnt get the block machined so yea. how much hp are u planning on running?
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Re-torque head gasket from 56 ft./lb. to 75 ft./lb. (Good idea or bad idea) | Randy0223 | MKIII Supra | 4 | 04-23-2011 09:50 PM |
| Blown Head Gasket? | BillW | MKIII Supra | 5 | 09-17-2010 02:06 AM |
| Head Gasket replacement questions. | DavidLeClair584 | MKIII Supra | 1 | 06-09-2007 09:17 PM |
| Buying a 87, head gasket questions | Gengus | MKIII Supra | 1 | 04-14-2007 07:15 PM |
| Head Gasket Part II | Bullz_EyE | MKIII Supra | 2 | 01-26-2006 06:30 PM |
Threaded Mode