03-25-2011, 09:41 AM
|
#4 |
|
Intake
Join Date: Feb 2011
Location: South of Columbus, Ohio
Posts: 45
 |
I see what you are saying....hmm...well, wouldnt you be able to "take up" the extra slack with the idler adjustment?
when i put it in time, i rolled it over 360* and it seemed to line back up perfectly. Would that cause it to completely fall on its face at 4000rpm and spit and stumble? It will BARELY make it to 6000. and only if i HOLD it to the floor.
__________________
86.5 Supra NA: milled head .020, decked block .007, .5mm+ pistons, port & polished intake manifold and cyl head,OBX header, 3-angle, cold air intake, Cometic MLS HG. ALL NATURAL!  CHEVROLET- Cracked Heads, Every Valve Rattles, Oil Leaks Every Time FORD- Flipped Over, Rebuilt Dodge DODGE- Dirty Old Dust Gathering Engine I'd rather drive a Toyota, than push a ford. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Best Cylinder Head Seal | Supra Saiyan | MKIII Supra | 5 | 02-06-2011 01:10 AM |
| torque settings for big end shells and cylinder head | johnkarl | MKIII Supra | 4 | 11-03-2006 04:01 PM |
| Cylinder Head?? | ZauggIt1 | MKIII Supra | 8 | 10-24-2006 01:51 AM |
| Valve Job On Head Now Car Wont Start? | MKIII shujin | MKIII Supra | 4 | 08-07-2006 02:16 AM |
Threaded Mode