![]() |
#2 |
![]() Toyota Racing Development Join Date: Apr 2007
Posts: 5,038
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
First off, the idle screw is a legacy component and not to be used on any of the 7M vehicles. If you have to adjust it to get a consistent idle then you haven't yet found the problem.
Second, have you checked for any diagnostic codes? Third, when setting the mechanical timing did you check to make sure that the #1 piston is at TDC when the indicator on the balancer says 0?? The rubber in the balancer can twist as it ages putting the 0? mark off more than 10?. Fourth, when setting the ignition timing, did you have the diagnostic jumper in place? Fifth, have you tested the ISC valve (electrical and mechanical) and it's plumbing? Sixth, I dunno what's with the counting.... Started with one and just had to go as high as I could (pathetic, I know).
__________________
If something breaks or you need to contact a member of the administration please post HERE. Unless it's a private or administration matter please post it on the forum. It benefits no one else if car related questions aren't posted for future users and takes away from the time I'm able to spend helping on the rest of the forum. If you're so inclined I'm always more than happy to accept tips via PayPal. ![]() Tip Jar ---> ![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
1986 1st Supra Running Poorly | dlfred | MKIII Supra | 41 | 04-03-2011 09:28 PM |
7mge hp increase info | 907mge | MKIII Supra | 14 | 02-05-2011 03:03 AM |
7MGTE to 7MGE | karu | MKIII Supra | 4 | 10-22-2010 07:22 AM |
Replace or Rebuild a 7mge | cbrewster | MKIII Supra | 2 | 03-19-2009 10:20 PM |