03-04-2011, 09:31 PM
|
#6 |
|
AEM EMS
Join Date: Jul 2006
Location: UK
Posts: 891
 |
The crank shaft pulley marking should be at 0 (zero) not 10 degrees. Its only when the pins in the check connector box are linked and the engine is ticking over will the pulley be at 10 degrees. To check no 1 piston is at top dead center I normally remove the No1 spark plug and insert a thin wooden dowel rod.
Last edited by Bill UK; 03-04-2011 at 09:33 PM. |
|
|
| Tags |
| 7mgte, ignition, timing |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Timing Knock or tap | batmmannn | MKIII Supra | 5 | 06-02-2010 03:20 AM |
| 7M~GTE ignition timing... | MA70-3.0GT | MKIII Supra | 4 | 03-20-2010 04:22 PM |
| Timing question | Kevin | MKIII Supra | 3 | 07-10-2009 07:52 PM |
| Ignition timing related to boost?? Need help | dieseltech24179 | MKIII Supra | 2 | 12-17-2008 07:26 PM |
| Ignition write up.. | midwestmk2 | MKII Supra | 0 | 06-11-2006 02:56 AM |
Threaded Mode