07-25-2010, 03:29 AM
|
#2 |
|
Super Moderator
Join Date: May 2007
Location: Billings, Montana
Posts: 1,034
 |
If you're sticking with the same transmission, and it stays in the same spot (not sure if it would need to move or not to accommodate the different engine), then you *should* be able to use the driveshaft. I'm not sure on the intake though...
__________________
1989 7MGTE R154 Targa Top White Package w/Blue Interior Driftmotion 57trim CT26, Upgraded Intercooler, 2.25" Hard Pipes, 3" Turbo Back Exhaust with Test Pipe, HKS VPC w/GM 3 bar MAP sensor, APEXi S-AFC, Walbro 255lph fuel pump, ProSport EVO Series Boost / Fuel Pressure / AFR gauges, Lotek a Pillar Gauge Pod, HKS Type 0 Turbo Timer, Eibach Lowering Springs, Tokico Illumina II TEMS struts, custom powder coated Motegi Racing TrakLite wheels |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Where to buy a Driveshaft Center Support Bearing 1986.5 NA-5spd | dlfred | MKIII Supra | 11 | 03-23-2011 10:39 PM |
| Driveshaft and center support bearing vibration | BillW | MKIII Supra | 10 | 03-03-2010 01:51 AM |
| can i get some info on the center support bearing?? | JZA70dood | MKIII Supra | 6 | 08-03-2009 04:01 PM |
| Center Support Bearing Problem | purplescott | MKIII Supra | 0 | 03-27-2006 10:17 PM |
| do luck middle support bar?? stiffin er up | joel w | MKIII Supra | 1 | 11-09-2005 03:07 PM |
Threaded Mode