A few questions from a newbie

joel w · 08-30-2005, 06:08 AM

the nice thing about a supra is the owners that are fanatical like you ppl. i dont even have a repair manual or owners manual and i only needed a machinist to do the valve
job. i have found every soulution to every issue i have had on the net from places and ppl this here, ive done a bhg, heater core, water pump, timing belt, lower crank pulley valve job, new used ebay turbo. new IC new hand made by me custom 4" k&n filter & adapter air filter hand made mandrel ICplumbing and custom mandrel exahaust sys all made by me from 2.5 inch aluminum and steel w/ 3 inch flowmaster muffler, all cats have been sleeved, fcd installed, ball joints, breaks, ujoint, and stage 3 clutch. like any car things break and wear out. there old but built very well . easy to work on quality nuts and bolts my advice is to get some quality metric tools and save$ for the bpu mods

boost tends to point out the weak link in the car so most parts are heavier duty than most n/a cars

thanks to all

h34r:

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Newbie Questions	Grandavi	MKIII Supra	0	08-20-2008 09:01 PM
Ten questions from a Newbie	swarm	Non-Generation Specific Questions	7	09-26-2006 08:14 PM
Supra newbie questions.	72charger	Non-Generation Specific Questions	4	07-30-2006 01:07 PM
Stupid Newbie Questions	Lord Umoja	MKIV Supra	3	01-12-2006 03:49 PM
newbie questions	erik	MKIII Supra	4	01-10-2006 11:37 AM

08-30-2005, 06:08 AM	#6
joel w Lexus & 550's Join Date: Aug 2005 Location: In the shadows Posts: 506	the nice thing about a supra is the owners that are fanatical like you ppl. i dont even have a repair manual or owners manual and i only needed a machinist to do the valve job. i have found every soulution to every issue i have had on the net from places and ppl this here, ive done a bhg, heater core, water pump, timing belt, lower crank pulley valve job, new used ebay turbo. new IC new hand made by me custom 4" k&n filter & adapter air filter hand made mandrel ICplumbing and custom mandrel exahaust sys all made by me from 2.5 inch aluminum and steel w/ 3 inch flowmaster muffler, all cats have been sleeved, fcd installed, ball joints, breaks, ujoint, and stage 3 clutch. like any car things break and wear out. there old but built very well . easy to work on quality nuts and bolts my advice is to get some quality metric tools and save$ for the bpu mods boost tends to point out the weak link in the car so most parts are heavier duty than most n/a cars thanks to all h34r: