04-09-2010, 11:28 PM
|
#7 |
|
3" Exhaust
Join Date: May 2008
Location: Sacramento
Posts: 60
 |
I went aluminum for the extra weight reduction. I heard that too about one pieces, that it's harder on some parts, but I haven't seen/felt anything that would make me worry. On the other hand, make sure your diff is mounted nice and secure, my friends decided to mess with me and loosen mine a bit as a joke, and I tore it free from the rear subframe one day while on the road.
A one piece is a bolt in part, since it's just replacing what you already have, nothing extra. If I had the money though, I'd strengthen my tranny with newer parts, but that's about it. Good luck.
__________________
1jz-gte swap (Currently spun #3 rod bearings), Apexi high flow filter, Greddy thrust 3" downpipe, N1 3" catback with cat delete tube, 1 peice driveshaft, Bar and Plate intercooler, and 440 JDM 2jz injectors. Possible 2jz lower block swap in the works if I can't rebuild the 1j. So troublesome. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Shop in Chicago | tone loc | Shops & Part Reviews | 3 | 08-06-2010 09:45 PM |
| Where do i look for machine shop? | Kevin | MKIII Supra | 1 | 05-15-2009 05:57 AM |
| any sugestion on a shop to buy a jdm 7mgte? | skadaloz | MKIII Supra | 1 | 05-15-2009 05:52 AM |
| Super Duper JDM Shop | HIGH END EAST | Non-Generation Specific Questions | 0 | 10-14-2007 07:48 PM |
| body shop questions | D_Train | MKIII Supra | 5 | 04-11-2007 06:23 PM |
Threaded Mode