12-08-2009, 10:11 PM
|
#4 |
 Toyota Racing Development Join Date: Apr 2007
Posts: 5,038
  |
I don't know about the availability over there, but here you can get "gasket remover" made by Permatex. It helps quite a bit (VERY nasty stuff). You may polish the deck surface with some ultra-fine sandpaper to finish the job (1200 grit or higher). Even with a grit that fine you need to make sure not to over work any one area... I recommend wrapping the sandpaper around a piece of plate glass to use as a make shift lapping plate.
Is there any pitting on the deck? |
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 7M-GTE Head torques on stock bolts... | MA70-3.0GT | MKIII Supra | 2 | 11-07-2009 04:58 PM |
Threaded Mode