Car wont idle (wont stay on)

Kevin · 09-01-2009, 04:18 PM

ok hey guys sorry for taking so long to get back to u on checking the tps. but i just did it just now and i am confused as shit... lol. i tried doing it the way the tsrm shows but its just too confusing for me? everything seems within spec. so i go to the page to adjust it. so i can adjust it. and it says insert .7mm thickness gauge so i did that.. then i check out idl and e2 with an ohm meter.. i get about 20 ohms then i rotate clockwise.. im supposed to rotate until it "DEFLECTS" ... what the hell does that mean? when i rotate it it read "0.L"... does that mean it deflected? lol. well i gotta put my car back together cuz i need to drive it. any advice would help. this is too confusing. and also my thickness gauge only goes up to .88mm and i need .9mm lol will that be a problem?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
idle problems	88 supra turbo	MKIII Supra	14	03-13-2010 03:43 AM
won't idle	3.0trd	MKIII Supra	6	06-15-2009 07:23 PM
Wastegate Idle issue... please help	Subjug4tor	MKIII Supra	9	05-15-2008 01:59 AM
Car doesnt like to idle in the morning	XxSupra4LifexX	MKIII Supra	11	12-24-2007 07:27 AM
HELP!!!! '87 Supra idle problem	Morpho	MKIII Supra	0	10-03-2005 02:40 PM

09-01-2009, 04:18 PM	#9
Kevin 3" Exhaust Join Date: Apr 2009 Location: Ontario, Canada Posts: 194	ok hey guys sorry for taking so long to get back to u on checking the tps. but i just did it just now and i am confused as shit... lol. i tried doing it the way the tsrm shows but its just too confusing for me? everything seems within spec. so i go to the page to adjust it. so i can adjust it. and it says insert .7mm thickness gauge so i did that.. then i check out idl and e2 with an ohm meter.. i get about 20 ohms then i rotate clockwise.. im supposed to rotate until it "DEFLECTS" ... what the hell does that mean? when i rotate it it read "0.L"... does that mean it deflected? lol. well i gotta put my car back together cuz i need to drive it. any advice would help. this is too confusing. and also my thickness gauge only goes up to .88mm and i need .9mm lol will that be a problem?