getting my distributor lined back up

Bill UK · 07-29-2009, 08:42 PM

I found the distributor a lot more difficult to line up than a CPS on the turbo. If you can get someone to turn the engine over whist you slightly rotate the distributor you may find it will start to fire up. If you get black smoke coming out of the exhaust, you should be nearly there. Pulling the engine is 3 times longer than a head gasket replacement. More parts to label up, more crawling under the car and with out doubt you will damage one or both of the engine mounts lifting the engine out. The first thing you will need is an engine hoist; I used a 2-ton hoist, when fully extended (which you will need) it will lift a ton. Another pair of helping hands makes the job a lot easer. I remember at the time (a few year ago now) saying never again, mind you I was doing a total strip down for a big end repair, but I would probably do it again tomorrow if I needed to.

One coming out & one going in.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
2.5" drop in front 2" in back?	supraman121	MKIII Supra	11	05-19-2010 05:48 PM
Back Bumper	TRAFIK	MKIV Supra	4	07-18-2008 03:28 AM
WAter not going back to raditor from recovery tank Help	Jeff_5_7	MKIII Supra	12	09-15-2006 03:49 AM
Need help putting engine back together	GreenChevelleSS	MKIII Supra	18	12-17-2005 05:37 PM
Thinking about getting back into a Supra	the_stig	MKIII Supra	5	07-03-2005 08:35 PM

07-29-2009, 08:42 PM	#4
Bill UK AEM EMS Join Date: Jul 2006 Location: UK Posts: 891	I found the distributor a lot more difficult to line up than a CPS on the turbo. If you can get someone to turn the engine over whist you slightly rotate the distributor you may find it will start to fire up. If you get black smoke coming out of the exhaust, you should be nearly there. Pulling the engine is 3 times longer than a head gasket replacement. More parts to label up, more crawling under the car and with out doubt you will damage one or both of the engine mounts lifting the engine out. The first thing you will need is an engine hoist; I used a 2-ton hoist, when fully extended (which you will need) it will lift a ton. Another pair of helping hands makes the job a lot easer. I remember at the time (a few year ago now) saying never again, mind you I was doing a total strip down for a big end repair, but I would probably do it again tomorrow if I needed to. One coming out & one going in.