10-22-2008, 04:32 PM
|
#5 |
|
12psi boost
Join Date: Mar 2007
Location: Sacramento, Ca
Posts: 373
 |
Ok I figured out how to test.. I used two paper clips, one in each of the terminals and got 4.9 volts with the water temp sensor unplugged and .8 when water temp sensor is plugged in. Also getting plenty of voltage from the +B terminal... So resistance of the water temp sensor is close to in range, I'm going to wait for it to cool down more and test again.... and all ECU terminals are putting out volts, so assuming that the sensor has the right amount of resistance I'm lost
 as to why it's throwing code 22.
Last edited by dannydavi; 10-22-2008 at 05:01 PM. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Error Codes 42 and 43 | Getphazed | MKIII Supra | 6 | 09-14-2008 10:32 PM |
| Codes 25,26,51! | justin1642 | MKIII Supra | 11 | 08-30-2007 08:08 PM |
| codes 22 24 31 | kidthunder650 | MKIII Supra | 16 | 04-12-2007 11:54 PM |
| Got Codes? | h8z2luze | MKIII Supra | 14 | 08-29-2006 01:48 AM |
| fault codes on a newly re-headed supra | lethalwithasupra | Non-Generation Specific Questions | 5 | 09-28-2005 08:22 AM |
Threaded Mode