Hello. You might already know me LOL

Simann · 06-03-2006, 01:17 AM

I admit, the paint is darn good for 18 years old. But it needs to be repainted especially the front bumper (greddy coming soon).

Of course I cannot leave out the "mods list". I have earned every right to post this crap up. Its too depressing not to tell people what I have worked for 2.5 years on. LMAO

SUSPENSION:

Full TEIN RA coilovers $500

SSR Vienna Gluck 17x8/17x9 22+ offset $1000

?? MCD tie rod ends

?? ST Sway bars

ENGINE:

Fully polished engine/ peripheral parts $100

Full teardown and rebuild at 153K miles. Everything is replaced and BRAND NEW. $1500

Lokar custom throttle cable $30

Schneider 272 degree 8mm lift camshafts $250

Comp Cams valve springs part #975 $80

New shims $250

New stainless steel valves $150

3 angle valve job $260

Mild port and polish on head exhaust/intake

HKS MHG $150

Race piston ring set. $80

Clevite 77 bearings $inside rebuild

All studs/bolts in motor are ARP $inside rebuild

Head Torque to 110lbs/ft

Lexan clear timing cover ( supra sport). $inside rebuild

SAMCO coolant lines ( blue) $inside rebuild

Greddy Timing belt ( blue) $inside rebuild

New battery

40K mile old radiator

Oil Filter relocation kit $75

/\ Thats the CURRENT motor inside the car. The new motor is going to be "race ready". Full head work/ custom bottem end.

FUEL SYSTEM:
550cc-720cc injectors $350

Walboro external 255lph pump $125

Sump for fuel tank $60

Custom lines $100

Aeromotive FPR kit $350

CHARGE INDUCTION/TURBO SYSTEM:

Custom T3/T4 ball bearing turbo. 55mm/.70 exhaust housing tange divided $350

Equal Length Tubular stainless manifold $150

4” Exhaust system with Burns stainless muffler $300

HKS 40mm Wastegate with external dump $100

23x12x3 Intercooler/ 2.5” piping/ Silicone couplers $400

Sethron71 Intake Manifold $450

Q45 Throttle Body $80

PROF sheepdog blow off valve. $50

IGNITION:

NGK 3330 plugs

NGK spark plug wires $100

?? HKS Ignition soon???

ELECTRONICS/GAUGES:
HKS FCON with 550cc chip $280

HKS VPC with 550cc chip $200

Apexi SAFC II $150

HKS FCD-K3 $60

ELECTRONICS/GAUGES:

Greddy Profec B spec 2 type S boost controller $150

HKS Turbo Timer type-0 $90

GAUGES:

Oil pressure $25

Oil Temperature $25

Water Temperature $25

Boost pressure $25

EGT?? $110

AEM Eugo wideband meter?? $280

TRANSMISSION:

Stock R154

RPS stage 3- 6 puck sprung ceramic clutch

RPS stage 3 clutch pressure plate (720ft/lbs torque capability) $600

Fidanza aluminum flywheel. $250

Supra Sport 1 piece aluminum drive shaft $450

Clutch stainless steel braided and teflon coated hard line. $60

New clutch master cylinder AND slave cylinder $80

B&M custom short throw shifter $100

SOUND SYSTEM:

Clarion Sterio $Thanks Dad

Boston speakers (4) $Thanks Dad

INTERIOR:

Nardi competition steering wheel. $100

Nardi Hub, genuine hub, not a knock off. $60

Kazama Auto Shift Knob $55

Kazama Auto Drift Knob $0

Levoc Japan Heel Toe Gas pedal $25

35% tint $ Thanks Dad

EXTERIOR:

AUTOPAL H4 housing glass headlights $45

HID ???

New paint/clear coat

Fix dent in rear
New drivers window due to break in.

Pending install:
Roll cage/ Harness bar $400
Veilside pedals $100
Willans or some other 3" harnesses $150
Custom carbon/fiberglass coweld hood< probably this summer.
Battery relocation kit. $150

( i have EVERY SINGLE record from the previos owner which was the ONLY owner of the car....Vanderbuilt UN. Proffesor.)

Simann · 06-03-2006, 02:28 AM

I will have tons of pics and parts listings for the motor I am building. Hopefully break into some serious hp numbers. My little 500hp mark probably will be easily reached.

SU9RA · 06-06-2006, 09:30 AM

nice work bro.... car looks great and yeh u should get some very decent power.... good luck

suprra_girl · 06-06-2006, 09:38 AM

that looks awesome and you got some toys to boot, gimme some!!! haha

i love that edited photo... gotta tell me how to do that lol

and that spelling mistake in post above was annoying me lol desent = decent

Simann · 06-11-2006, 12:55 AM

Axcuse me supa gurrllll. Mu spallung iz nut dat grueat!

hahah.

My friend Stephen King ( no joke, like the book writer) went to video/picture production school in Nashville for 3 years. He has everything you could imagine to take proffessional pictures ( well he is a proffesional ).

-Jonathan

PS: Supra is in the storage place now. All safe and sound. Away from the heat of the summer. Hahah. I used my money that I was going to build the motor internals with for this:

1991 4x4 4runner SR5. Completely mint condition. One original owner. Bought in in my neighborhood during a neighborhood "yard sale" LOL. I spent 12 hours washing and waxing the whole truck last tuesday.

joel w · 06-11-2006, 01:26 AM

Nice list dude.. Got any HP #'s on thet setup yet?

Edit: I just saw your 500hp mark post... my bad...

IHateHacks · 06-11-2006, 11:26 PM

Who sells the Oil Filter relocation kit $75?

06-03-2006, 01:17 AM	#1
Simann Intake Join Date: May 2006 Location: Murfreesboro Posts: 42	I admit, the paint is darn good for 18 years old. But it needs to be repainted especially the front bumper (greddy coming soon). Of course I cannot leave out the "mods list". I have earned every right to post this crap up. Its too depressing not to tell people what I have worked for 2.5 years on. LMAO *SUSPENSION:* Full TEIN RA coilovers $500 SSR Vienna Gluck 17x8/17x9 22+ offset $1000 ?? MCD tie rod ends ?? ST Sway bars *ENGINE:* Fully polished engine/ peripheral parts $100 Full teardown and rebuild at 153K miles. Everything is replaced and BRAND NEW. $1500 Lokar custom throttle cable $30 Schneider 272 degree 8mm lift camshafts $250 Comp Cams valve springs part #975 $80 New shims $250 New stainless steel valves $150 3 angle valve job $260 Mild port and polish on head exhaust/intake HKS MHG $150 Race piston ring set. $80 Clevite 77 bearings $inside rebuild All studs/bolts in motor are ARP $inside rebuild Head Torque to 110lbs/ft Lexan clear timing cover ( supra sport). $inside rebuild SAMCO coolant lines ( blue) $inside rebuild Greddy Timing belt ( blue) $inside rebuild New battery 40K mile old radiator Oil Filter relocation kit $75 /\ Thats the CURRENT motor inside the car. The new motor is going to be "race ready". Full head work/ custom bottem end. *FUEL SYSTEM:* 550cc-720cc injectors $350 Walboro external 255lph pump $125 Sump for fuel tank $60 Custom lines $100 Aeromotive FPR kit $350 *CHARGE INDUCTION/TURBO SYSTEM:* Custom T3/T4 ball bearing turbo. 55mm/.70 exhaust housing tange divided $350 Equal Length Tubular stainless manifold $150 4” Exhaust system with Burns stainless muffler $300 HKS 40mm Wastegate with external dump $100 23x12x3 Intercooler/ 2.5” piping/ Silicone couplers $400 Sethron71 Intake Manifold $450 Q45 Throttle Body $80 PROF sheepdog blow off valve. $50 *IGNITION:* NGK 3330 plugs NGK spark plug wires $100 ?? HKS Ignition soon??? *ELECTRONICS/GAUGES:* HKS FCON with 550cc chip $280 HKS VPC with 550cc chip $200 Apexi SAFC II $150 HKS FCD-K3 $60 *ELECTRONICS/GAUGES:* Greddy Profec B spec 2 type S boost controller $150 HKS Turbo Timer type-0 $90 *GAUGES:* Oil pressure $25 Oil Temperature $25 Water Temperature $25 Boost pressure $25 EGT?? $110 AEM Eugo wideband meter?? $280 *TRANSMISSION:* Stock R154 RPS stage 3- 6 puck sprung ceramic clutch RPS stage 3 clutch pressure plate (720ft/lbs torque capability) $600 Fidanza aluminum flywheel. $250 Supra Sport 1 piece aluminum drive shaft $450 Clutch stainless steel braided and teflon coated hard line. $60 New clutch master cylinder AND slave cylinder $80 B&M custom short throw shifter $100 *SOUND SYSTEM:* Clarion Sterio $Thanks Dad Boston speakers (4) $Thanks Dad *INTERIOR:* Nardi competition steering wheel. $100 Nardi Hub, genuine hub, not a knock off. $60 Kazama Auto Shift Knob $55 Kazama Auto Drift Knob $0 Levoc Japan Heel Toe Gas pedal $25 35% tint $ Thanks Dad *EXTERIOR:* AUTOPAL H4 housing glass headlights $45 HID ??? New paint/clear coat Fix dent in rear New drivers window due to break in. Pending install: Roll cage/ Harness bar $400 Veilside pedals $100 Willans or some other 3" harnesses $150 Custom carbon/fiberglass coweld hood< probably this summer. Battery relocation kit. $150 ( i have EVERY SINGLE record from the previos owner which was the ONLY owner of the car....Vanderbuilt UN. Proffesor.) __________________ http://www.delkperformance.com/index.cfm http://members.aol.com/Racepower/team.htm

06-03-2006, 02:28 AM	#2
Simann Intake Join Date: May 2006 Location: Murfreesboro Posts: 42	I will have tons of pics and parts listings for the motor I am building. Hopefully break into some serious hp numbers. My little 500hp mark probably will be easily reached. __________________ http://www.delkperformance.com/index.cfm http://members.aol.com/Racepower/team.htm

06-06-2006, 09:30 AM	#3
SU9RA Stock Join Date: May 2006 Location: MELBOURNE Posts: 10	nice work bro.... car looks great and yeh u should get some very decent power.... good luck Last edited by suprra_girl; 06-06-2006 at 09:37 AM.

06-06-2006, 09:38 AM	#4
suprra_girl 7M POWAH! ;) Join Date: Jun 2004 Location: New Zealand Posts: 2,312	that looks awesome and you got some toys to boot, gimme some!!! haha i love that edited photo... gotta tell me how to do that lol and that spelling mistake in post above was annoying me lol desent = decent __________________ Please use the forum to ask your questions as they will get replied to much faster than pming me Pics of my build. "Good girls are just bad girls that don't get caught" Do a diagnostic first!

06-11-2006, 12:55 AM	#5
Simann Intake Join Date: May 2006 Location: Murfreesboro Posts: 42	Axcuse me supa gurrllll. Mu spallung iz nut dat grueat! hahah. My friend Stephen King ( no joke, like the book writer) went to video/picture production school in Nashville for 3 years. He has everything you could imagine to take proffessional pictures ( well he is a proffesional ). -Jonathan PS: Supra is in the storage place now. All safe and sound. Away from the heat of the summer. Hahah. I used my money that I was going to build the motor internals with for this: 1991 4x4 4runner SR5. Completely mint condition. One original owner. Bought in in my neighborhood during a neighborhood "yard sale" LOL. I spent 12 hours washing and waxing the whole truck last tuesday. Attached Thumbnails __________________ http://www.delkperformance.com/index.cfm http://members.aol.com/Racepower/team.htm

06-11-2006, 01:26 AM	#6
joel w Lexus & 550's Join Date: Aug 2005 Location: In the shadows Posts: 506	Nice list dude.. Got any HP #'s on thet setup yet? Edit: I just saw your 500hp mark post... my bad... Last edited by joel williams; 06-11-2006 at 03:09 AM.

06-11-2006, 11:26 PM	#7
IHateHacks 20psi boost Join Date: May 2006 Location: New Haven/Hamden Posts: 793	Who sells the Oil Filter relocation kit $75?