Forum: MKIII Supra
09-15-2009, 12:06 AM
|
|
Replies: 3
Views: 2,371
It's not just hp. It's also a question of...
It's not just hp. It's also a question of low-end torque, your differential ratio, your fuel system, your tires, your suspension... a small host of things.
As an aside, I personally see little...
|
|
Forum: Non-Generation Specific Questions
09-15-2009, 12:02 AM
|
|
Replies: 1
Views: 2,154
|
|
Forum: Show n Tell
09-07-2009, 04:47 PM
|
|
Replies: 27
Views: 31,580
|
|
Forum: MKIII Supra
08-19-2009, 02:21 AM
|
|
Replies: 1
Views: 2,399
Well lets see. The ones to the power steering...
Well lets see. The ones to the power steering pump are about the only ones that aren't necessary/needed, but pulling them will prevent the engine from reving slightly when the wheels are cranked...
|
|
Forum: MKIII Supra
08-14-2009, 08:31 PM
|
|
Replies: 29
Views: 25,354
Might want to check your AFM. If you've gone...
Might want to check your AFM. If you've gone through all the vacuum lines (and there are a BUNCH of them, some tucked away and hiding), check your AFM connections and the I/C piping for problems.
|
|
Forum: MKIII Supra
08-12-2009, 12:17 PM
|
|
Replies: 12
Views: 5,796
|
|
Forum: MKIII Supra
08-12-2009, 12:13 PM
|
|
Replies: 5
Views: 7,456
|
|
Forum: MKIII Supra
08-12-2009, 12:11 PM
|
|
Replies: 6
Views: 3,584
There's all kinds of aftermarket body panels,...
There's all kinds of aftermarket body panels, aero skirting, and spoilers available for use on whatever kind of car you want to put them on. Most of them look like crap in my personal opinion, but...
|
|
Forum: MKIII Supra
08-12-2009, 02:19 AM
|
|
Replies: 5
Views: 7,456
Rebuild time, or at the very least time to pull...
Rebuild time, or at the very least time to pull the oil pan and find out which of your rod/crank bearings are toasted. When the engine heats up and the tolerances open up your oil pressure falls at...
|
|
Forum: MKIII Supra
08-12-2009, 02:14 AM
|
|
Replies: 6
Views: 3,584
|
|
Forum: MKIII Supra
08-12-2009, 02:10 AM
|
|
Replies: 7
Views: 4,319
|
|
Forum: MKIII Supra
08-12-2009, 02:08 AM
|
|
Replies: 12
Views: 5,796
|
|
Forum: Non-Generation Specific Questions
08-12-2009, 02:05 AM
|
|
Replies: 12
Views: 8,727
Here's a pic of the ks locations...
...
Here's a pic of the ks locations...
http://i13.tinypic.com/29lmmj9.jpg
The front one is kinda hiding back underneath the intake plenum and manifold, the rear one is tucked in underneath the...
|
|
Forum: MKIII Supra
08-12-2009, 12:29 AM
|
|
Replies: 6
Views: 3,584
Dealers could install them by request/order, or...
Dealers could install them by request/order, or someone may have gone to the trouble of getting one off a parts car and putting it on. But if it's not put on with factory hardware it's probably just...
|
|
Forum: Non-Generation Specific Questions
08-12-2009, 12:22 AM
|
|
Replies: 12
Views: 8,727
That's a diagram of one of your VSV's, not a...
That's a diagram of one of your VSV's, not a knock sensor. You can bolt it up anywhere or nowhere so long as the wiring connector is secure and you have the vacuum lines to it hooked up properly.
|
|
Forum: MKIII Supra
08-11-2009, 06:52 PM
|
|
Replies: 7
Views: 3,303
|
|
Forum: Non-Generation Specific Questions
08-11-2009, 06:50 PM
|
|
Replies: 12
Views: 8,727
The replacement wiring segment for the KS is...
The replacement wiring segment for the KS is Toyota Part #82219-89103. That listing is for another vehicle entirely, but the KS's are the same for both. All you have to do is splice in the new...
|
|
Forum: MKIII Supra
08-11-2009, 06:47 PM
|
|
Replies: 12
Views: 5,796
|
|
Forum: MKIII Supra
08-11-2009, 03:47 PM
|
|
Replies: 12
Views: 5,796
|
|
Forum: Non-Generation Specific Questions
08-11-2009, 03:45 PM
|
|
Replies: 12
Views: 8,727
|
|
Forum: MKIII Supra
08-07-2009, 12:04 AM
|
|
Replies: 6
Views: 2,534
No worries, understood. And their manuals they...
No worries, understood. And their manuals they have on hand may well still say 58 ft/lbs, but that's a bad number. Him claiming that he's never heard of a BHG problem on the 7M just means he's...
|
|
Forum: MKIII Supra
08-06-2009, 01:51 PM
|
|
Replies: 3
Views: 2,920
|
|
Forum: MKIII Supra
08-06-2009, 01:50 PM
|
|
Replies: 6
Views: 2,534
On OEM bolts you want to do 72 ft/lbs as the...
On OEM bolts you want to do 72 ft/lbs as the original spec of 52 or whatever ft/lbs is simply way too low. After about 5 heat-cycles, loosen them slightly, one at a time in the proper sequence, and...
|
|
Forum: MKIII Supra
08-05-2009, 11:25 PM
|
|
Replies: 3
Views: 3,324
|
|
Forum: MKIII Supra
08-05-2009, 04:40 PM
|
|
Replies: 3
Views: 3,324
|
