Toyota Supra Forums! Join the Supra forum!

		Toyota Supra Forums! Join the Supra forum! > Search Forums
Search Results

Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: cre

Forum: MKIII Supra

06-06-2022, 03:03 AM

Replies: 24

how does milling the cylinder head affect the valve timing??

Views: 10,831

Posted By cre

WOW! Resurrected after over 11 YEARS!?! :eek2:

WOW! Resurrected after over 11 YEARS!?! :eek2:

Forum: MKIII Supra

04-04-2011, 06:33 AM

Replies: 24

how does milling the cylinder head affect the valve timing??

Views: 10,831

Posted By cre

Wow.... piece of work. He was just going by...

Wow.... piece of work.

He was just going by the pic and due to the angle it DOES look like it could be off a tooth.

As for the belt, yes, some are dead perfect and some a hair off.... That's...

Forum: MKIII Supra

04-03-2011, 10:17 PM

Replies: 24

how does milling the cylinder head affect the valve timing??

Views: 10,831

Posted By cre

As usual, no idea what on Earth you are talking...

As usual, no idea what on Earth you are talking about... RTFM. On a N/A, which is what this person has, you can only use wire #1 to check timing. On a GTE you may use either #1 or #6 as they always...

Forum: MKIII Supra

04-01-2011, 07:58 PM

Replies: 24

how does milling the cylinder head affect the valve timing??

Views: 10,831

Posted By cre

I wouldn't do that... First I would try...

I wouldn't do that...

First I would try bypassing the fuel pump relay and resistor (passenger fender) as it switches around 4K.... if that doesn't do anything either I'd take it from the top:
...

Forum: MKIII Supra

03-31-2011, 05:29 AM

Replies: 24

how does milling the cylinder head affect the valve timing??

Views: 10,831

Posted By cre

You're wrong... On both counts. You can only use...

You're wrong... On both counts. You can only use #6 on the GTE for timing as it runs a wasted spark setup, not so on the GE; You MUST have the engine at normal operating temperatures, no critical...

Forum: MKIII Supra

03-31-2011, 12:56 AM

Replies: 24

how does milling the cylinder head affect the valve timing??

Views: 10,831

Posted By cre

If it's bogging under ~4KRPM then check all the...

If it's bogging under ~4KRPM then check all the vacuum plumbing under the intake plenum. A problem with the ACIS system will cause sluggishness at lower RPM.

Yes, 10?BTDC with the diagnostic...

Forum: MKIII Supra

03-26-2011, 01:14 AM

Replies: 24

how does milling the cylinder head affect the valve timing??

Views: 10,831

Posted By cre

A non-interference engine is only such as long as...

A non-interference engine is only such as long as the distance between the piston crown and the valves isn't reduced beyond a given point. I don't remember how much room you've got on the 7M before...

Showing results 1 to 7 of 7

Forum Jump

All times are GMT. The time now is 12:18 PM.