Home / Toyota Supra Forums

Go Back   Toyota Supra Forums! Join the Supra forum! > Search Forums

Showing results 1 to 10 of 10
Search took 0.00 seconds.
Search: Posts Made By: ksd9000
Forum: MKIII Supra 06-20-2011, 12:45 AM
Replies: 7
Views: 3,298
Posted By ksd9000
Toyota service manual states the WG should open...

Toyota service manual states the WG should open at 7.4 PSI.
Forum: MKIII Supra 06-20-2011, 12:41 AM
Replies: 11
Views: 4,338
Posted By ksd9000
TLA? Not sure what that is? Fuel pump and...

TLA? Not sure what that is?

Fuel pump and filter replaced. Runs like a banshee!

Appears the evap system is deleted. No canister. How do I overcome the vacuum build up? Car didt have any of it...
Forum: MKIII Supra 06-18-2011, 05:30 AM
Replies: 7
Views: 2,249
Posted By ksd9000
Your dad has it backwards... BHG causes the...

Your dad has it backwards...

BHG causes the coolant to dump into the catalytic converter that causes it to fail, get clogged up etc.

Tighten the head to 80 ft lbs. If you are palanning to run...
Forum: MKIII Supra 06-18-2011, 05:11 AM
Replies: 11
Views: 4,338
Posted By ksd9000
***UPDATE**** OK, so I got an aftermarket...

***UPDATE****

OK, so I got an aftermarket boost gauge and hooked it up. Did some more testing and found that the WG actuator was not moving. BTW I bought a blood pressure cuff at CVS and used the...
Forum: MKIII Supra 06-15-2011, 10:37 PM
Replies: 11
Views: 4,338
Posted By ksd9000
Ok, so I got a BOSCH BPV and installed. Now I...

Ok, so I got a BOSCH BPV and installed. Now I dont have the same noise as before. However, i think I'm hitting fuel cut???? In 2nd gear at WOT the boost pegs past the stock gauge limit and the engine...
Forum: MKIII Supra 06-15-2011, 01:12 AM
Replies: 11
Views: 4,338
Posted By ksd9000
Thanks for all the help CRE. Did some more...

Thanks for all the help CRE.

Did some more testing and found that the BSV is not closing. Relieving pressure all the time. I have been looking into the Saab BSV P/N 0 280 142 110 as an...
Forum: MKIII Supra 06-14-2011, 09:55 PM
Replies: 11
Views: 4,338
Posted By ksd9000
Its the stock bypass valve. And the IC rubber...

Its the stock bypass valve. And the IC rubber piping is surprisingly still soft and pliable. Plus I cleaned all the piping out thoroughly before reassembly.

Applying vacuum at idle should make the...
Forum: MKIII Supra 06-14-2011, 04:07 PM
Replies: 12
Views: 12,707
Posted By ksd9000
Follow the instructions at the link below. Also,...

Follow the instructions at the link below. Also, if you have not removed the CPS or done anything else to cause it to be out of alignment since last start up, then its most likely not the sensor...
Forum: MKIII Supra 06-14-2011, 02:36 AM
Replies: 11
Views: 4,338
Posted By ksd9000
Boost issues-Stuck BOV?

Hello all. Just got done rebuilding the engine and running into some issues. All components are stock except for the 3" turbo back exhaust. No CAT and just a free flow muffler at the end.

The...
Forum: MKIII Supra 05-17-2011, 11:19 PM
Replies: 2
Views: 4,049
Posted By ksd9000
Try these guys

Sent my 7mgte harness and they rebuilt it to factory new condition for $400. Every connector new and any wires damaged replaced with correct color coded wire and length. They also sell just pigtails...
Showing results 1 to 10 of 10

 
Forum Jump

All times are GMT. The time now is 11:54 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.

1986



1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87