Forum: MKIII Supra
11-13-2006, 02:39 AM
|
Replies: 7
Views: 2,760
|
Forum: MKIII Supra
11-04-2006, 12:22 AM
|
Replies: 7
Views: 2,760
|
Forum: MKIII Supra
11-03-2006, 12:41 AM
|
Replies: 7
Views: 2,760
Knocking Under Acceleration
Hello everyone,
On my 87 NA Automatic, I'm getting a knock under acceleration. The noise is coming from around the transmission / driveshaft and I'm suspecting a bad u-joint. The engine was...
|
Forum: MKIII Supra
04-02-2006, 12:39 AM
|
Replies: 3
Views: 2,563
Coils...
Turns it that it was due to my pickup coils, actually. The ground coil somehow got destroyed, so I am looking at a new distributor. That would explain the troublecode...
|
Forum: MKIII Supra
04-02-2006, 12:33 AM
|
Replies: 2
Views: 1,951
|
Forum: MKIII Supra
03-31-2006, 01:48 PM
|
Replies: 2
Views: 1,921
|
Forum: MKIII Supra
03-30-2006, 10:28 PM
|
Replies: 3
Views: 2,563
Okay, minor update.
After consulting TSRM...
Okay, minor update.
After consulting TSRM and Haynes more closely...
The coil is fine. .6 ohms is within acceptable range. I'm working my way down the Haynes list and my high-tension cord...
|
Forum: MKIII Supra
03-29-2006, 11:31 PM
|
Replies: 3
Views: 1,831
|
Forum: MKIII Supra
03-29-2006, 08:51 PM
|
Replies: 3
Views: 2,563
Distributor Circuit Problems
Okay, I just swapped in a JDM engine and the thing has been giving me difficulty left and right, it seems. The other day, it would crank, fire, and run, but misfiring all the while til it died. I...
|
Forum: MKIII Supra
03-21-2006, 03:21 PM
|
Replies: 6
Views: 2,035
Try this out for the manual:
...
Try this out for the manual:
http://www.cygnusx1.net/supra/library/TSRM/index.html
As for the A/C problem, I think there is another thread in the forums that have addressed it... trying...
|
Forum: MKIII Supra
03-21-2006, 03:19 PM
|
Replies: 11
Views: 5,525
Thanks again for the tips. A brief update...
...
Thanks again for the tips. A brief update...
We've decided to leave the balancer on for the time being. If there's a problem with it down the road, then we'll address it, but the motor is rather...
|
Forum: MKIII Supra
03-19-2006, 02:38 PM
|
Replies: 11
Views: 5,525
The JDM actually came with the '89 mounts...
...
The JDM actually came with the '89 mounts...
The problem is that they look to be unable to bolt to the chassis of the 87; we considered shimming them to where it meets the block, but that would...
|
Forum: MKIII Supra
03-19-2006, 12:30 AM
|
Replies: 11
Views: 5,525
|
Forum: MKIII Supra
03-16-2006, 08:59 PM
|
Replies: 11
Views: 5,525
Balancer Removal Tip
I asked a question similar to this one before, though this time, the circumstance is different.
I am looking to remove the harmonic balancer off of the block.
This time, however, there is a...
|
Forum: MKIII Supra
03-16-2006, 08:49 PM
|
Replies: 6
Views: 2,035
|
Forum: MKIII Supra
03-16-2006, 08:46 PM
|
Replies: 5
Views: 4,999
|
Forum: MKIII Supra
03-16-2006, 06:01 PM
|
Replies: 18
Views: 4,545
|
Forum: MKIII Supra
03-12-2006, 01:57 PM
|
Replies: 8
Views: 2,121
|
Forum: MKIII Supra
03-11-2006, 04:42 PM
|
Replies: 8
Views: 2,121
|
Forum: MKIII Supra
03-11-2006, 01:57 PM
|
Replies: 8
Views: 2,108
The starter relay, if I remember, is on the...
The starter relay, if I remember, is on the passenger side kick panel. You'd have to remove the plastic cover (there is a nut on a stud that holds it in) and the junction block is along the right...
|
Forum: MKIII Supra
03-07-2006, 06:26 PM
|
Replies: 0
Views: 2,264
Air Control Valve
I managed to break off one of the ports removing my power steering pump. This is the small, two-port valve that is screwed into the back of the pump housing. Is this a dealer-only part or is there...
|
Forum: MKIII Supra
03-04-2006, 12:58 AM
|
Replies: 0
Views: 1,816
Swap Project
Okay, after having searched and read through 15 pages of thread titles, I didn't see one matching mine.
I suspect a blown head / piston rings in my 7MGE. Start it up, runs rough, oil shooting out...
|
Forum: MKIII Supra
01-06-2006, 11:23 PM
|
Replies: 5
Views: 2,784
I think that I braced it at a place where the...
I think that I braced it at a place where the torque wrench wouldn't be damaged... anyways, I haven't checked Sears yet... good idea to do so. I'm going to try the balancer puller since it seems to...
|
Forum: MKIII Supra
01-06-2006, 02:55 AM
|
Replies: 5
Views: 2,784
Front Main Seals
Okay, question number two... I guess I should have posted the first and second together since they're both being worked on during my replacement.
My issue is that I suspect both front main seals...
|
Forum: MKIII Supra
01-05-2006, 09:59 PM
|
Replies: 4
Views: 2,368
Thanks guys. Upon closer inspection of the...
Thanks guys. Upon closer inspection of the regulator, I saw that there were pinholes in the side, thus spraying fuel onto my engine as it was running... talk about a combustion hazard! Replaced it...
|