7mge head

Bill UK · 11-22-2006, 07:23 PM

10mm hexagon drive (Allen key type) with 3/8 socket, not sure if you can get a 1/2 socket passed the cam, (bit of a tight squeeze in some places) you will properly need to rotate the cam to gain access to some of the bolts. Make sure the hexagon drive is well seated to the bottom of the head bolt and keep it vertical otherwise you could damage the head of the bolt. I used 10mm hexagon dive with 3/8 socket then converted it to 1/2 drive just outside the head so I could use my 1/2 torque wrench when tightening back up. Do you know the correct sequence of undoing the bolts?
http://www.cygnusx1.net/Supra/Librar...ion=EM&Page=39

11-22-2006, 07:23 PM	#5
Bill UK AEM EMS Join Date: Jul 2006 Location: UK Posts: 891	10mm hexagon drive (Allen key type) with 3/8 socket, not sure if you can get a 1/2 socket passed the cam, (bit of a tight squeeze in some places) you will properly need to rotate the cam to gain access to some of the bolts. Make sure the hexagon drive is well seated to the bottom of the head bolt and keep it vertical otherwise you could damage the head of the bolt. I used 10mm hexagon dive with 3/8 socket then converted it to 1/2 drive just outside the head so I could use my 1/2 torque wrench when tightening back up. Do you know the correct sequence of undoing the bolts? http://www.cygnusx1.net/Supra/Librar...ion=EM&Page=39 Last edited by Bill UK; 11-22-2006 at 07:33 PM. Reason: added link

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
7mgte head on 7mge block?	RCSG_MK	MKIII Supra	4	01-01-2008 02:01 PM
7mge head same or not from 7mgte	demon2supra	MKIII Supra	4	05-31-2007 07:38 AM
7MGE - Stuck with changing Head Gasket???	pasupra	MKIII Supra	8	07-31-2006 10:41 AM