question about JDM 1jz-gte engine age

[supramacist]

I just hate the thought of even having to rebuild a jdm.

But I would. And I can see where the clip would be a huge bonus plus plus.

That way you would have a template for fab work.

[finaltable]

This place: http://www.japanmotorimport.com/JDM_.../1JZGTTE_92-95Says it includes this:

Complete Motor 5spd Manaul Transmission
Uncut wire hurness ECU
Alternator Air Conditioning
Power Steering Pump Intake Manifold
Starter 2 Turbos
Engine Control Unit Throttle Body
Fuel Rail Clutch kit
Injectors Fly Wheel

For $1800 + shipping

[supramacist]

You should be able to ship it anywhere basically in the continental U.S. for right around 500 bucks.

[finaltable]

Is that a typical package for a JDM "clip" or is a clip something else?

[supradaddy0803]

If it was a clip it will say front clip or something like that. That is for the motor and such already out of the car. This isnt a bad thing but the fact is a clip costs a whole lot more than that like this web site. http://www.rimsandthings.com/jdm_clips.htm#mitsubishiin the toyota section you will see how much a clip usually runs in price. You could go either way it is completly up to you. Sometimes you can find a clip on ebay with body panels and everything they usually are already imported and shipping is cheaper. kinda like this 2JZ clip http://cgi.ebay.com/ebaymotors/2JZ-G...QQcmdZViewItem
just kinda shows what you are looking for.

[finaltable]

Since I'm putting a 1JZ in a Mk III I don't really want a "clip" then, do I?

[supradaddy0803]

The only thing it will make easier is with the clip you will get the plugs you need under the dash and the hood that have to be swapped so all of the dash and EFI harness will work. But as for those if you can find the part number for them I am sure you can get them from the dealer and the pins as well.