|
![]() |
#1 |
Super Moderator
Join Date: May 2007
Location: Billings, Montana
Posts: 1,034
![]() |
![]()
Well, I'd have to disagree (for now anyway)... I haven't gotten everything running smoothly yet (my error in connecting vacuum lines, now have a vacuum leak causing some mild revving and stalling), so it's still possible to have problems, but I bought a JDM engine off of eBay. When I finally got it started, the engine itself sounded great. No knocking or anything else, tt just purred.... So I'm kinda stoked about it. The engine cost me $450 bucks, and I picked it up from the warehouse in LA, so I didn't have to ship anything. Also haven't found any fluid leaks from the engine. Only downside is you have to install all of your emissions components and engine accesories (i.e. alternator, power steering pump, water pump, distributor, etc.), so it can be a headache.
__________________
1989 7MGTE R154 Targa Top White Package w/Blue Interior Driftmotion 57trim CT26, Upgraded Intercooler, 2.25" Hard Pipes, 3" Turbo Back Exhaust with Test Pipe, HKS VPC w/GM 3 bar MAP sensor, APEXi S-AFC, Walbro 255lph fuel pump, ProSport EVO Series Boost / Fuel Pressure / AFR gauges, Lotek a Pillar Gauge Pod, HKS Type 0 Turbo Timer, Eibach Lowering Springs, Tokico Illumina II TEMS struts, custom powder coated Motegi Racing TrakLite wheels |
![]() |
![]() |
![]() |
#2 |
12psi boost
Join Date: Feb 2007
Location: Waukegan, IL
Posts: 255
![]() |
![]()
I had bought a JDM turbo motor from ebaymotors and I had paid $990 for it shipped and I did and did not like the motor. They said that they do a compression and leak down test but I think that was BS.
The good about my motor-everything looked new, cylinder head had pretty much no wear, you can tell that it had very low miles, sensors was in good condition. The bad about my motor- motor had a BHG, pitting around the coolant passages and I had to switch some sensors, install the EGR and stuff, switch the throttle body's but over all I did part out my old turbo motor and I made all of my money back+ some more and now im in the process of rebuilding my JDM motor.
__________________
1987 Toyota Supra Turbo-burgundy exterior w/gray interior+1987 Toyota Supra(N/A) light brown top,dark brown bottom w/light brown interior. |
![]() |
![]() |
![]() |
#3 |
12psi boost
Join Date: May 2006
Location: Athens, TX
Posts: 308
![]() |
![]()
I bought mu 1JZ clip from ebay took a while to get here and some other costs that I wasnt told about but it runs awsome. Other problem is the shipping company damaged the intercooler so now I am waiting till the guy gets me a new intercooler. other than that good experience.
__________________
1987 supra NA 5 speed 1JZGTE swap Tokico Illumina 2 and Eibach springs Tokico pillow blocks Suspension Techniques front and rear sway bar HKS super dragger cat-back exhaust plus test pipe Greddy Profec B spec 2 boost controller HKS type 1 turbo timer Supra sport solid steel drive shaft Walboro 255 fuel pump JZA70 Front end mod 18" Volk Racing AV3 18x8.5 front 18x9.5 rear |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Engine Help! | born2drv | MKIII Supra | 9 | 02-01-2011 08:14 PM |
problem seperating engine from manual tranny | Gengus | MKIII Supra | 7 | 01-29-2008 12:10 AM |
Keeping Engine Cool | mrnickleye | Supra FAQ | 0 | 06-04-2005 10:02 PM |