So Basically you could buy this http://cgi.ebay.com/ebaymotors/92-95...QQcmdZViewItem
comes with engine, wiring harness, and trans.. So if you bought this then you would have to change the driveshaft, get new engine mounts (if its pre 89), intercooler, tubing, change power steering lines, Change A/C lines, Electric fan, water pump off the JZ2, and change the wirers in the dash, and the tach. Is this correct. Did i miss anything

hello to all. i have a 1jz and i swap out for a 1jz-gte. but the motor came from japan. there a few plugs on the wiring harness. that .are not on any page.iam just trying to find out. what these plugs are for.if any infoe.would be so much help. i tryed to post pic.but it telling. me it fail to load.thought iam new at this wed page. so if some 1 can help.it would be great. here my email address jupiterlast@comcast.net. i look every where.for infoe.but i can.t find it lol. mabe it me i will email the pic may there peace thanks

hello to all
 

hello to all. i have a 1jz and i swap out for a 1jz-gte. but the motor came from japan. there a few plugs on the wiring harness. that .are not on any page.iam just trying to find out. what these plugs are for.if any infoe.would be so much help. i tryed to post pic.but it telling. me it fail to load.thought iam new at this wed page. so if some 1 can help.it would be great. here my email address jupiterlast@comcast.net. i look every where.for infoe.but i can.t find it lol. mabe it me i will email the pic may there peace thanks

After reading. You can use the W-58 transmission with a 7M-GTE? Just using as a daily driver? Really all you have to do is drop in the 7M-GTE, with inter cooler and everything. bolt it to the W-58 transmission, plug it all in and go?