02-26-2007, 02:54 AM
|
#2 |
|
12psi boost
Join Date: May 2006
Location: Athens, TX
Posts: 308
 |
It is actually easy you basically look on the back of the spindle and you will see a castlated nut on the bottom and the top the one on the bottom is the one you are looking for. Pull the cotter pin out and loosen the nut heres the fun part pop the stud out of the spindle and remove the three bolts from the lower A arm and the whole assembly slides out. I looked all over when I got ready to do mine they dont even actually sell ball joint to be pressed out the assembly you buy is the one you need.
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lower Ball Joints - Checking here first | Grandavi | MKIII Supra | 3 | 09-20-2008 04:04 AM |
| power steering problem | 3.0trd | MKIII Supra | 12 | 06-24-2008 01:17 PM |
| Tie Rods & Ball Joints | mrnickleye | MKIII FAQ | 1 | 03-10-2007 04:50 AM |
| Tie Rod End and Ball Joints!! | KrnSupra2307 | MKIII Supra | 6 | 02-27-2007 11:01 PM |
Threaded Mode