01-03-2007, 10:02 PM
|
#2 |
|
20psi boost
Join Date: May 2006
Location: New Haven/Hamden
Posts: 793
 |
A wire brush is not the tool to use on cylinder walls, the cylinder head sealing surfaces or the block sealing surface. I used a whiz wheel, which is an air tool much like a die grinder except its angled and the wheel is made of 3M Scotch material which is made for aluminum. A wire wheel would take off too much metal and a wire brush will just ruin the sealing surface.
You're not sending the head out to have it tested for cracks or warpage? |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Head torque | Kuban | MKIII Supra | 7 | 04-24-2007 11:12 AM |
| Arp Head Stud Torque Settings!?!?!?!?!? | papaleach | MKIII Supra | 2 | 11-22-2006 08:20 PM |
| torque settings for big end shells and cylinder head | johnkarl | MKIII Supra | 4 | 11-03-2006 04:01 PM |
| Head bolt torque | kjhsupra | Non-Generation Specific Questions | 3 | 04-06-2006 09:19 AM |
| Torque Specifications (ARP Head Studs)??? | Dejvid1785 | MKIII Supra | 5 | 03-06-2006 02:59 AM |
Threaded Mode