11-25-2006, 11:23 PM
|
#7 |
|
Stock
Join Date: Aug 2006
Location: Union City, NJ
Posts: 19
 |
Been there did that....
So I reset the engine to TDC and reinstalled the Camshaft sensor, the timing now looks to be about right, but it is still a close thing. I am at the end of the play in the cam sensor. Its also now acting funky during idle, it will be fine for a minute or two and then start to drop and idle really rough for a couple minutes seem on the edge of stalling and then recover, run fine for a minute or two and then start the cycle again. I checked the diag and it says it is registering a "Too rich" condition. Is this a bad O2 sensor? I think I am idling a little on the low side as well, I think it is about 450 but I am not sure of the accuracy of my Tach.
Lunch
__________________
'89 Supra Turbo 5-speed, 3" stainless exaust |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1991 n/a timing problems | jerrods91supra | Non-Generation Specific Questions | 0 | 07-06-2008 09:44 PM |
| advanced timing? | sd88supra | MKIII Supra | 7 | 04-27-2008 03:44 PM |
| Timing question. | supramacist | MKIII Supra | 53 | 04-26-2008 11:41 AM |
| Photos of my timing belt | Nato99 | MKIII Supra | 7 | 08-27-2007 09:33 PM |
| timing issues | stuck1 | MKIII Supra | 0 | 03-27-2006 02:16 PM |
Threaded Mode