No power to anything....

h8z2luze · 08-11-2006, 09:34 PM

Its bran new, i tested it its putting out 12.5 volts. The wires are hot as far down into the motor as I can reach. It worked fine before I started the job. I bought a MAIN fuse and it wasnt that 17 bucks down the drain...

h8z2luze · 08-12-2006, 04:12 AM

I figured it out. It was the small wire comming off the positive terminal. It was broke right were the connector ended. SO I got it started, and it idles like CRAP all the timing is right or close enough. Moving the distributor doesnt seem to affect it much. It almost seems like a vaccum leak. BUT then when it warmed up some it ran better. But it kept dieing at idle when I stopped. Any ideas?

h8z2luze · 08-12-2006, 06:45 PM

bump......

damdog05 · 08-12-2006, 06:53 PM

how are your intake tubes? mine was pretty crappy and a section kept slipping off the rest, and that causes the engine to die since its no longer getting air. maybe check that

h8z2luze · 08-12-2006, 11:09 PM

They look good. It acts like its not getting fuel. But only at idle. If I give it gas it works fine. Could It be off time?

08-11-2006, 09:34 PM	#1
h8z2luze 12psi boost Join Date: May 2006 Location: Nor*Cal Posts: 338	Its bran new, i tested it its putting out 12.5 volts. The wires are hot as far down into the motor as I can reach. It worked fine before I started the job. I bought a MAIN fuse and it wasnt that 17 bucks down the drain... __________________ 1989 Supra 7MGE MK3 5-speed project... http://www.cardomain.com/ride/2385505

08-12-2006, 04:12 AM	#2
h8z2luze 12psi boost Join Date: May 2006 Location: Nor*Cal Posts: 338	I figured it out. It was the small wire comming off the positive terminal. It was broke right were the connector ended. SO I got it started, and it idles like CRAP all the timing is right or close enough. Moving the distributor doesnt seem to affect it much. It almost seems like a vaccum leak. BUT then when it warmed up some it ran better. But it kept dieing at idle when I stopped. Any ideas? __________________ 1989 Supra 7MGE MK3 5-speed project... http://www.cardomain.com/ride/2385505

08-12-2006, 06:45 PM	#3
h8z2luze 12psi boost Join Date: May 2006 Location: Nor*Cal Posts: 338	bump...... __________________ 1989 Supra 7MGE MK3 5-speed project... http://www.cardomain.com/ride/2385505

08-12-2006, 06:53 PM	#4
damdog05 12psi boost Join Date: Apr 2006 Location: Georgia Posts: 250	how are your intake tubes? mine was pretty crappy and a section kept slipping off the rest, and that causes the engine to die since its no longer getting air. maybe check that __________________ My cars: 85 Trans Am- Ehhh- Gone 83 Rx7- Much Better- Gone 86.5 Supra- Love- Not Gone

08-12-2006, 11:09 PM	#5
h8z2luze 12psi boost Join Date: May 2006 Location: Nor*Cal Posts: 338	They look good. It acts like its not getting fuel. But only at idle. If I give it gas it works fine. Could It be off time? __________________ 1989 Supra 7MGE MK3 5-speed project... http://www.cardomain.com/ride/2385505

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Greetings!	importauto	Import Auto Center	7	06-21-2009 07:42 AM
getaway in stockholm... (i think thats how you spell it)	kelogg	Road Racing & Autocross	3	06-03-2008 10:53 PM
Lsd	RussianMK3	Drifting	6	12-10-2006 05:42 PM
Ghetto is a good seller	ARZ	Buyer/Seller ratings	0	11-15-2006 11:58 PM
MEET UP's	TEAM_Bastos	Drifting	0	03-02-2006 09:09 PM