need help replacing 89 supra front and rear brake pads

[ebang]

it's not always that easy.......I removed the wheel and the lower caliper bolt...but the caliper would not budge (slide up)...seems that the top bolt that is supposed to swivel was seized up...I had to hammer the caliper up and take the whole assembly off...then again hammer the caliper off the part the holds the pads on the rotors...grease all parts and put back together...( oh yeah had to get new top caliper bolts cuz the hammering bent the old ones)..this was for both sides...now i had to bleed them...well the bleeder screws were rusted to hell and both broke off...removed all parts again and drilled off the broken bleeder screws...made sure the thread were fine...one was good and tapped the other. I ordered new bleeder screws and will be back at it again tonight...