proud 1st time owner of 87 supra turbo

marcusproctor90 · 03-30-2012, 02:46 AM

I checked my trouble codes and I believe. 24 41 51 came up. Ill start checking my vacuum lines. It doesn't do it when I rev the motor only driving when the turbo kicks in

cre · 03-30-2012, 03:34 AM

There may be vacuum line problems but the code 41 and code 51 are going screw with throttle state transitions (ie: the ECU cant's tell that you're flooring it until it's been floored for a few seconds already and it has a difficult time knowing when it's supposed to start modulating the ISCV for proper idle). The code 24 is going to screw with your fuel mixtures. While code 51 could just be an alignment issue the code 41 indicates damage in the TPS or its wiring.

I don't entirely understand your question about the head gasket. Yes, there is a ledge which protrudes out from under the head on the driver's side. It's supposed to be there. What else are you asking?

marcusproctor90 · 03-30-2012, 05:44 AM

Well I know my alignment is off and I believe the 24 code came up because I disconnected the o2 sensor for a minute. I hooked it back up but it still read.but I guess my main question is why would my car die after I floor it then let off the gas?

cre · 03-30-2012, 07:25 AM

Code 24 has nothing to do with the O2 sensor.... N O T H I N G.

As I've mentioned, all of these codes are in one way or another capable of affecting your throttle and idle transitions. Please don't make me bang my head on my desk.... I do that far too often around here. You've proven you can check for codes. Now go that extra three feet and fix them. There are many things which cause the stalling... I suggest we speculate on the other possibilities AFTER you fix what your ECU is already telling you is suspect.

marcusproctor90 · 04-09-2012, 03:59 PM

Welll I think I solved the stalling issue. There is a little adjustmentbolt/screw where the actual throttle rod meets the rest of the throttle body. I adjusted that and the stalling stopped. I figured it was snapping the throttle all the way shut before. I still have code 24 tho. So if its not the o2 sensor what is it? I only thought that cuz I read it on another forum.

cre · 04-09-2012, 06:06 PM

When he throttle is closed... guess what... it's supposed to be CLOSED. Quit dicking with things you have no idea about just because you think it might be a good idea and go buy a service manual. The idle is controlled via a computed controlled valve which bypasses the throttle body altogether. Your code 51 indicates a possible problem with the switch that's built into the TPS to tell the ECU when the throttle is closed.

Look in the MKIII FAQ section for a thread on diagnostic codes for a list and descriptions of the various codes.

marcusproctor90 · 04-09-2012, 08:41 PM

Look I'm here to learn. I'm pretty good with cars but a supra is a lil more complex the a 95 accord so gimme a break here. Now I do realize that code 24 is an air fuel mix issue. So. Could my afm be the culprit? U answered my question on another thread about using a different afm by the way which I appriciate. And I do plan to get a service manual but moneys short right now. The car as I said before is my daily driver. It runs good just little things id like to take care of before I start getting really indepth with it. I appriciate the help and sorry for making u bang ur head on the desk. Like I said I'm new to the supra scene. Oh and I checked my codes again and 41 was not the right code it was 31. So 24 31 and 51 are the codes that it throws fyi. I'm. Mainly focusing on the air fuel mix right now tho.

03-30-2012, 03:34 AM	#2
cre Toyota Racing Development Join Date: Apr 2007 Posts: 5,038	There may be vacuum line problems but the code 41 and code 51 are going screw with throttle state transitions (ie: the ECU cant's tell that you're flooring it until it's been floored for a few seconds already and it has a difficult time knowing when it's supposed to start modulating the ISCV for proper idle). The code 24 is going to screw with your fuel mixtures. While code 51 could just be an alignment issue the code 41 indicates damage in the TPS or its wiring. I don't entirely understand your question about the head gasket. Yes, there is a ledge which protrudes out from under the head on the driver's side. It's supposed to be there. What else are you asking? __________________ If something breaks or you need to contact a member of the administration please post HERE. Unless it's a private or administration matter please post it on the forum. It benefits no one else if car related questions aren't posted for future users and takes away from the time I'm able to spend helping on the rest of the forum. If you're so inclined I'm always more than happy to accept tips via PayPal. Tip Jar --->

03-30-2012, 07:25 AM	#4
cre Toyota Racing Development Join Date: Apr 2007 Posts: 5,038	Code 24 has nothing to do with the O2 sensor.... N O T H I N G. As I've mentioned, all of these codes are in one way or another capable of affecting your throttle and idle transitions. Please don't make me bang my head on my desk.... I do that far too often around here. You've proven you can check for codes. Now go that extra three feet and fix them. There are many things which cause the stalling... I suggest we speculate on the other possibilities AFTER you fix what your ECU is already telling you is suspect. __________________ If something breaks or you need to contact a member of the administration please post HERE. Unless it's a private or administration matter please post it on the forum. It benefits no one else if car related questions aren't posted for future users and takes away from the time I'm able to spend helping on the rest of the forum. If you're so inclined I'm always more than happy to accept tips via PayPal. Tip Jar --->

04-09-2012, 06:06 PM	#6
cre Toyota Racing Development Join Date: Apr 2007 Posts: 5,038	When he throttle is closed... guess what... it's supposed to be CLOSED. Quit dicking with things you have no idea about just because you think it might be a good idea and go buy a service manual. The idle is controlled via a computed controlled valve which bypasses the throttle body altogether. Your code 51 indicates a possible problem with the switch that's built into the TPS to tell the ECU when the throttle is closed. Look in the MKIII FAQ section for a thread on diagnostic codes for a list and descriptions of the various codes. __________________ If something breaks or you need to contact a member of the administration please post HERE. Unless it's a private or administration matter please post it on the forum. It benefits no one else if car related questions aren't posted for future users and takes away from the time I'm able to spend helping on the rest of the forum. If you're so inclined I'm always more than happy to accept tips via PayPal. Tip Jar --->

04-09-2012, 08:41 PM	#7
marcusproctor90 Stock Join Date: Mar 2012 Location: coos bay oregon Posts: 10	Look I'm here to learn. I'm pretty good with cars but a supra is a lil more complex the a 95 accord so gimme a break here. Now I do realize that code 24 is an air fuel mix issue. So. Could my afm be the culprit? U answered my question on another thread about using a different afm by the way which I appriciate. And I do plan to get a service manual but moneys short right now. The car as I said before is my daily driver. It runs good just little things id like to take care of before I start getting really indepth with it. I appriciate the help and sorry for making u bang ur head on the desk. Like I said I'm new to the supra scene. Oh and I checked my codes again and 41 was not the right code it was 31. So 24 31 and 51 are the codes that it throws fyi. I'm. Mainly focusing on the air fuel mix right now tho. __________________ 87supra turbo. Kyb shocks. catback exhaust non targa

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Installation of T61 turbo on a mkiii supra	ahruizguerra	MKIII Supra	1	12-02-2010 11:19 PM
Possibly Buying Supra 1994 Twin Turbo	bswan9015	MKIV Supra	6	11-05-2009 12:29 AM
First time Supra buyer. Tips/Advice. See setup inside plz	pisto	MKIII Supra	1	09-13-2009 01:28 PM
Turbo trouble with JDM supra	wollis	MKIV Supra	2	06-06-2009 08:41 PM
New to forum...1989 Bright Red Targa Turbo Supra Virgin, Pics included.	whowouldfigga	Show n Tell	3	03-13-2008 07:47 PM

03-30-2012, 02:46 AM	#1
marcusproctor90 Stock Join Date: Mar 2012 Location: coos bay oregon Posts: 10	I checked my trouble codes and I believe. 24 41 51 came up. Ill start checking my vacuum lines. It doesn't do it when I rev the motor only driving when the turbo kicks in

03-30-2012, 05:44 AM	#3
marcusproctor90 Stock Join Date: Mar 2012 Location: coos bay oregon Posts: 10	Well I know my alignment is off and I believe the 24 code came up because I disconnected the o2 sensor for a minute. I hooked it back up but it still read.but I guess my main question is why would my car die after I floor it then let off the gas?

04-09-2012, 03:59 PM	#5
marcusproctor90 Stock Join Date: Mar 2012 Location: coos bay oregon Posts: 10	Welll I think I solved the stalling issue. There is a little adjustmentbolt/screw where the actual throttle rod meets the rest of the throttle body. I adjusted that and the stalling stopped. I figured it was snapping the throttle all the way shut before. I still have code 24 tho. So if its not the o2 sensor what is it? I only thought that cuz I read it on another forum.