11-20-2011, 04:23 AM
|
#8 |
|
3" Exhaust
Join Date: Jun 2011
Location: Wisconsin
Posts: 177
 |
So you think i would be better off just getting hex bolts, washers, and rubber grommets? I was thinking about doing that if the felpro ones i was looking at was just the rubber piece. I did already buy 6 of the 12 bolts i need from a hardware store locally and i was going to go back and get 6 more when they were in stock. Also I dont have a torque wrench. I plan on getting one next week but the think is the one im looking at is 20-150 foot pounds. So the lowest i could get in inch pounds is 240. I really dont have the money 2 of them and besides that, the lowest one they have only goes down to 20 inch pounds
__________________
1988 7M-GTE Manual Turbo, Godspeed IC, Stock HG Torque to 90FP W/ Arp bolts, Silicon water hose kit, silicon vacuum hoses, Godspeed radiator, 2 12" electric fans. |
|
|
| Tags |
| cover, grommet, seal, valve, washer |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Grommets and Valve Cover | Green7mgte | MKIII Supra | 1 | 06-04-2010 03:28 AM |
| Valve cover vent hose | Durandal | MKIV Supra | 3 | 07-14-2009 01:53 AM |
| valve cover gasket question? | sevenmgte | MKIII Supra | 8 | 10-01-2008 06:02 AM |
| 88 Turbo Leaking Valve Cover Gaskets | Sheridan | MKIII Supra | 1 | 11-05-2007 01:03 AM |
| valve cover leaking | Supra 90 | MKIII Supra | 0 | 10-22-2007 09:35 AM |
Threaded Mode