BHG question.
 

Hey guys I have an 89 auto n/a supra with a bhg I am just looking to get the car running right not do any crazy upgrades. I am planning on just using a stick gasket and arp head bolts and having the head machined. I am just wondering do I have to do anything to the block or is there anything else I need to do while doing this job? I am trying to keep cost down as money isn't readily valuable right bow but these needs to get done shortly. I am just looking for some advice and if there is anything else that is recommended I look at or replace while doing the head gasket that may restore lost horsepower.

As long as there's no significant pitting or indentions then just follow the TSRM and inspect for warping and flatness. Make sure it's very clean too. I'd thoroughly clean the carbon build up off of the piston crowns while you're in there too... Mopar Combustion Chamber Conditioner (MCCC) works well as a soak to loosen it up; Just spray and let it sit a couple hours, while out and repeat.

Absolutely do not forget to chase the threads in the block! And do not forget the RTV at the block/rear timing plate union!!! These are biggies!

hey cre can u explain what is chase threads!
thanks im kinda learning cre going 4 auto tech soon!
I HAVE TO GET SUM KINDA BELT LOL!

A thread chase is essentially a non-cutting tap. It's used to reshape and space threads. If you don't have a chaser or can't find one you may use a tap, just be very careful getting it started as it will cut new threads and mangle the existing ones if you don't get it in straight. (NEVER use either with a drill! Hand power only!) Lubricate it well and remove it and clean it about every 1/4" to prevent shavings and dirt from chewing up the threads. Then when you're ready to install lube the hell out of the bolts with the included moly grease and torque in steady, even passes.

I'm just going to cut and paste what I've posted before:

Retorque after a few hundred miles:
http://www.toyota-supra.info/forums/77288-post10.html