Is that the kit from china? The hose quality doesn't look half bad in the pictures.
The inner diameter of the hose should help you find where it goes to. There are coolant hoses on the throttle body as well as the iac valve and turbo, see if any of those are a match.

Ok. I have to take off the whole intake basically to replace a hose in the back. I know 2 hoses that i wont be using because they were for to stock BOV.

hey just ideas, it never hurts but yea the hoses look decent

I am going to use a drain plug to plug the hole on the intake. I still can't figure out where two of the hoses go. Here some pics. Maybe someone will know.

The little one look alike the one that goes to the bottom of the throttle body or the idle control valve.

Does this diagram show all the hoses that are used for coolant and such? Cause my kit came with 21 pieces. I hate being so close to done and not knowing where the other two go. lol.

alas i am finished. Actually i finished last week. I just got my silicon vacuum hoses and will start putting those in tomorrow. After that i will post some pics and tell how it went. And if anyone is interested i can post where i got the vacuum hose from and the silicon hose kit form as well.

Alright here's some pics of the silicon hose kit that replaced almost all of my coolant hoses. Also i did the red silicon vacuum lines too. I didnt buy a kit for the vacuum lines. I found a guide that gave me how many feet i would need of each inside diameter. All hoses seemed to be good quality to me. If anyone wants any info on them let me kno.

Wow that's nice I can't wait to get mine kit